1993 Jeep Grand Cherokee LTD
Does anybody have a copy of the fuse box diagram that they could send me?
Apparently its not in the Haynes manual and only exists in the owners
manual....that I never received.

Yesterday I had a  strange noise comming from around the A/C clutch,
sounds like it could be a bearing going out on the pully (noise goes
away when clutch engages), now today went to run an errand and it would
not start, after finally getting it to start, would not stay running,

Thinking about a low mileage(21K) 2004 Grand Cherokee Laredo 4.0
Selectrac. Has DC fixed many of the problems common to late '90s ZJs
I.e. leaks, axle problems, trans problems, or have there been new ones?
I did notice different trans cooler line fittings, an external fuel

I just purchased the 2000 Cherokee with 135k miles. I'm trying to snuff
it up all the way around. The fuel filter is my next concern. Where is
it located??? Can't seem the find it. Do I need to install an inline
filter? What is you recommendation? Thanks from a new Jeep driver.

I Recently found out that mustang 5.0 19lb fuel injectors will fit a 94
4.0 wrangler. So searching through google groups i noticed that many
people including myself was wondering if this would be a quick and fun
upgrade. I myself own a 95 wrangler with a 4cly. Through many people

Haven't sold that darn thing yet, but I drive it around and sometimes after
I drive for 30 mins. or so then go back to crank the thing up again an hour
later it doesn't want to start, just turns over.  I usually turn the key
forward in the ignition for a few seconds, then back ...

I put on a set of mopar factory fog lights.  The blinkers do not work nor do
the hazards.  The kit i got included the wiring harness, lights, and new
switch.
I thought the switch was bad, but I got a replacment switch and still no

http://cars.rasoenterprises.com/Propane-Holley.htm
At one time, Holley Carburetors (Colt Industries) were involved in LPG
carburetion and modified their gasoline carburetors to supply gaseous
fuel.  Very little is commonly known about Holley's propane carburetors

I was googling the groups as of late, trying to figure out how to get my
fender flares black again.  I saw the posts about using a heat gun, and with
a little hesitation tried it out.
Wow!  I'm a believer now.  Whoever came up with the idea.. I'll buy ya a

Over the past 7-10 days I have been loosing power with my '83 258 engine to
the point where it is difficult to drive and keep running.  It feels like I
am pulling a trailer, and I am getting rapid machine gun style backfiring
through the muffler when I get around 2000 RPM.   It ...

'73 CJ-5, Dana 30 front-end... got the wheel bearings from AutoZone (2
per wheel, an inner and an outer).  They have them listed as the same,
but the race for the outer is sloppy in the hub.  The hub obviously
hasn't been "wallered out" (as these local Tennesseans would say) but

1995 Jeep Grand Cherokee Limited, I-6, close to 150K miles.
It cranks sluggishly.  It actually starts ok because it's firing up on
what may be the first rev but it's really slow sounding.  Battery was
about 30 months old.  Spec. gravity thingy with the floating balls said

So, what's the first thing I should do? I ask cause I'm the guy they
can see comin' from miles away.
Thanks
Sam

Acura RDX brings on-road stability to 4X4
at http://www.washtimes.com/autoweekend/20060706-012219-4165r.htm
Does a Jeep need this?
Mike

Just to follow up:  I never got around to doing anything
myself, but after the oil change Clementine sat for 4 days
and then started perfectly.  Thanks for all the fun
suggestions, but between a boat project and a cracked rib I