This may be a stupid question. I am getting around to doing a little work on
the truck (85 Grand Wagoneer).
I replaced the starter. Not a big deal. Easy to get to but a "dirty job".
Fixed the tailgate window motor. Then recharged the air conditioner. Gas was

I don't know much about cams, so I'm looking for you're help on camming my
CJ.  I mostly drive it on the street, but I want it to be quite off-road
capable as well.  It's got an '82 Wagoneer 360 in it with a K&N filter,
Edelbrock performer intake, Edelbrock 600cfm carb, MSD ...

NEWSLETTER
Vol.1 No.13
The Kick Your Tires survey
If you own, lease or are about to buy or sell a vehicle.

I just bought a used '89 YJ. The engine was replaced and is supposedly
not that old.
I have beed dripping some oil after I park and have been investigating
the leak. I went through the usual recommenations of checking valve

saturday I was bored & wanted to live'n up my Jeep so I called a friend up
to my shop that has painted a few bikes... I asked if he could do flames and
this is what turned out 8 hrs later!
http://pg.photos.yahoo.com/ph/jsprauer2000/album?.dir=2bfb

I am a first time TJ owner and ordered two front tow hooks and a hitch
from the dealer.  I found out after the fact that they charge $79 bucks
an hour to install.  He said it would take three hours to do this...
does that sound right?  If not, about how long should it take?  Is this

I have a 2002 TJ jeep 6 cyl 4.0.  On the clutch pedal there is a part
that attactes to the firewall.   This is a black plastic, that has 2
wires attached to it.   This part has become detatched and can slide up
and down the link.

OK this was the thread about the growling 95 XJ.
I have gotten to the point where the front drive shaft is removed and the
transfer case noise is gone.
If I rotate the front drive shaft yoke by hand the bearing seems ok, but

I have this borken sensor on the back of the head, near that back on
the drivers side. There is a connector on it with a single yellow wire.
Is that the intake air sensor? And if not what is  it.

I snapped my d35 this weekend past...although the way the rock was wedged in
between the wheel and frame stopping the wheel from turning I would imagine
that any axle would have snapped...
http://media.putfile.com/d35-SNAP

Folks, I have a 1989 Wrangler. I would like to add a class III hitch to
the rear. The bumper is flush with the tailgate and there are two oval
shaped things attached to it on each side of the spare tire -
presumably to act as bumper/shock absorbers in the event of a hit.

geocities.com/arlene3542
geocities.com/bradley6048
geocities.com/delia7531
geocities.com/dorthy6115

Wife's 95 XJ - I6, automatic transmission
Previously there was a clicking at low speed and growl at higher speed,
inspection showed that both front axle U-joints were bad..... replaced them
this weekend (big thanks to Mike R. for the 'sacrificial bolt' trick and

A few weeks ago I bought a modified D***e pickup. Yesterday, I went
over down the way to an Amsoil dealer and got some of the hypoid gear
oil and transmission gear oil products and changed out the oil in the
(probably stock) rear end and the Clark 5 speed transmission. I drove

Anyone know what would cause my fuel pump to run what seems like, from
the sound, continuously wide open? When I start the jeep I can normally
hear it for a second or 2 while it comes up to pressure then it runs
quietly.  When it is acting up I hear the loud noise continuously.  The