The window went down in the driver door and wont go back up. Power to it
okay.
Is there a web site that shows picks of the regulator, et-al so I can clean
it up? Maybe make it work for a little while longer?

Is there any way to use a transfer case from a YJ in a CJ. Is it possible to
make the front output come out the passenger side? I have never seen one.

1989, Jeep Cherokee - 6cyl / 4.0L - Fuel Injected
200,000 mi on jeep - has had rebuilt engines put in and etc during life
of Jeep
Question - Are all Fuel Injectors basically the same ?  I need to

I have an 85 with an aftermarket non computer controlled carter bbd carb.
What is the procedure for setting the 2 adjutable screws with springs around
them on the front lower portion of the carb.

Jeep Trailer for sale
I have a military Jeep trailer I am thinking about selling. Is anyone
looking for one before I put it on ebay.
I am located in Ne Pa.

I have never seen a 96 Wrangler, is there such a thing?
Not a big deal just a question
Thanks
Andy

Hey Folks
I have a 93YJ, 2.5" spring lift, 31" bfg AT's and have a couple of
questions.
the ax15 in it needs to be replaced or repaired. 3rd gear synchros dont

I need to remove a spacer gear on an AX-5 transmission that is located
on the counter shaft next to the fifth gear. It looks to be the final
thing I need to remove to disassemble the gearbox with the intentions
of doing a full sync ring job.

Anyone want to guess what sort of mpg might be expected from the upcoming
GC turbo diesel?

I've got a 2002 TJ Sahara that has had a lingering problem that I have
yet to resolve.  Whenever I'm on a highway, and reach speeds between 60
and 69 mph, the front end will start to vibrate and bounce -- it almost
feels like a wheel is leaving the ground.  Once I hit 70+, it stops

well its been about 2 days since i posted and not one response - i took
a quick look down the list and there seem to be a lot of unanswered
posts these days... not like it used to be. i can only assume its
because of our list 'crasher'. good job you loser. whatever issues you

hey all - need some help...
just completed about 98% of a Carter BBD card rebuild and have two
major issues... one is that after removing the two small pins from the
stepper motor i accidently pushed the pin holder back into the stepper

I picked up a new lower ball joint today and went with the heavy duty
one that still had a grease nipple.
They also have a light duty one listed.
I was reading the directions and it says for a typical Spicer 44 front

My father-in-law has a 95 YJ with the 2.5L and 5-spd manual.  Would he
be able to put 4.88's in there or is he limited to 4.56's?  I think it
has 4.11's from the factory.
Thanks,

Went wheeling my '87 YJ a couple weeks ago, pushed it a bit more than
usual. Mostly dirt with some serious mud holes but no rocks to stress
things. Managed to break the vacumn switch on the transfer case, fixed
that, went to check out the 4wd. As soon as I put ANY load on the