It looks like fun
http://www.pirate4x4.com/forum/showthread.php?t=521188

I have a '97 Grand Cherokee with the 5.2L V-8.  When the car sits for a while
(more than 4 hours or so) it starts very hard.  I have discovered that if I
cycle the key from off to on and let the fuel pump run and do this a few
times it starts right up.

My wife has a 2001 jeep grand cherokee.
We had the brakes done yesterday - new pads -
and now the emergency brake handle can hardly be pulled up.
I can do it, but my wife can barely lift the handle,

There are two listings on the front rotors,Composite
3 3/16 and  Cast 3 1/16in.
   Can either be used on a 2000 Cherokee 4L?

I have a blog around cars, driving and reviews. It can be accessed via
http://drivechannel.blogspot.com/
You are welcome!

I've a Jeep CJ7 Golden Eagle V8 '79 automatic (TH400) with quadra-trac
(and low range).
I'm looking for a complet rebuild kit for my TH400.
Somebody knows where can I find that kit ?

Last night, got regular unleaded (87 oct) for $1.93 a gallon.
It's hard to believe that Diesel is still $2.54.
This means that the truck is sitting more than the jeep is these days.
Kate

CHECK GAUGES: Zero Oil Pressure reading-
First had this problem on my way back home, I  stuck in traffic, in the
middle of the summer.  It was a hot day, and I had been driving for 40
minutes.  I was at 4,000miles with  my oil, which is 5 part synthetic,

Replaced the water pump today, and noticed some grunge build upon the
radiator near the top hose. Can anybody recommend a replacement
radiator dealer for my 97 XJ w/air? Has anybody had experience with
Radiatorbarn.com?

Anybody know of a source to buy automotive wiring terminators and
color-coded, automotive wiring?
 What I'm talking about is, inside the plastic connection housings, the
little metal wire ends that clip in to the connector.  I'd rather not just

I'm a long time YJ owner, and need something bigger. I've been looking
around at 4.0L ZJs and XJs . Most everything in my price range has higher
miles, which doesn't necessarily bother me. I've had 2 YJs with over 150K
each and the 4.0 is probably the most reliable engine I've ever ...

Hi I would like to know how to pull the rear axle from this model of jeep I
do not see the C-lock from the inner axle shaft from in the Haynes manual
that I have is there something that I am missing? tried to push the axle
in after pulling the pinion shaft from the differential but ...

Just installed a replacement steering gear box on my 83 CJ7 - and in
doing so I couldn't get the tie rod end off the pitman arm, so I
basically unscrewed it from the rest of the tie rod - then installed
the pitman arm/tie rod end onto the replacement gearbox and screwed the

I've seen this mentioned a few times on this forum as a possible
diagnosis for a poster with a rough idle complaint, but have yet to
find the solution... According to previous posts, it's "pretty easy"...
But again, no one's mentioned the easy solution.

can anyone tell me what the exact specs are for the XJ's rear leaf spring
bolts?  I'm changing the rear springs and am afraid that I may have to use
new bolts in the process.  I would like to pick up a set of 4 new bolts just
in case.