Just bought an 86 Cherokee 2.8 and oil pressure readings seem weird.
I've just read all the postings covering low oil pressure. (A lot of
postings.) The sender often seems be the prime suspect.
When I first start the engine the gauge shows about 40 pounds and

I have a Jeep Sport Cherokee 2000. (85,000 miles)
If I replace one cyclinder and later the same problem show up, do I
have to replaced the whole valve?
Thanks

Anyone a member of http://autos.groups.yahoo.com/group/jeepcherokees/
or/and http://autos.groups.yahoo.com/group/jeep/
Mike

Can someone direct me in the right direction here. I want to put a
lift on my YJ. At least 2 inches. What are my options. What would be
the most effective, yet the most economical. I don't want to go crazy,
just want a little more clearance. I have 30" tires and think I'm

So I'm getting good vacuum using the very imprecise "finger over the hose
end" at the CCV hose, and the TPS sensor goes from about 1 to 5 volts.  Is
there some other things I should check?
Today it behaved differently than usual, hitting close to 3000 rpm while

I have a 76 Jeep CJ7, Recently my turn signals stopped working, so I
thought it was the flasher/relay. I replaced it. Still no turn
signals. In addition, when I apply the brakes, the front turn signals/
parking lights illuminate with the brakes, so it looks like my brake

Is their a serious downside to using 10W40 as opposed to 10W30 in a
2002 TJ as I appear to have a lot more choice of oils at this weight
than the 10W30 in full synthetics.  I was reluctant to go down to the
0W30 & 5W30 unless anyone has an opinion to the contrary as I do not

I'll preface this post with this caveat: I'm an idiot.
That being said, I tore off the transfer case on my 83 CJ7 and tossed
it. I now need a new one. But where? Any leads?
Mike Weber

What a forum!! Lots of great info. Scary info. Just bought my first
Jeep. First week or two have been awesome!, with some clunking noises
that I just chalked up to "a Jeep thing".
Now graduating from clunking/rattle in the rear end over the tiniest

Here's the story, jeep hasn't ran for couple months, went to start it the
other day to move it out of garage, it was dead, jumped it, moved it out of
garage, tried starting again, just click click, click, I figured battery was
gone as this is the same one I left lights on for a ...

I have replaced the battery. the connections are clean. Not sure what
else to do.

Greetings. I just purchased a set of Aluminum wheels from a friend.
They are from his 98 Sahara, stock rims. The ones with the five hole
pattern. I will be putting them on my 95 Sahara. I think it's gunna
look really nice! Anywho my question is, what is the best way to clean

..just finished installing a new clutch on my 85 cj7 /amc 150
4popper.  Now the clutch won't disengage...I bled the hydraulic clutch
system...I'm sure I put the disc on properly...the only way i could
get it to work was to use a 6 inch socket extender in place of the

April Fool! :-)

I am going to insall a Class III hitch on my 2006 Unlimited, and I
have several options.  I can either install the Mopar hitch, whose
towing capacity is 3,500 lbs with a 350 lb tongue weight, or a Curt
hitch that has 400 lbs tongue and 4000 lbs capacity.