I've got a Koenig winch ???????? don't know what the model or specs
are on it. The only numbers I can find on it are; 524 and 49064. I
believe this unit would be classified as a PTO winch since it
currently driven by a hydraulic motor (oilfield application). I'm

I have a new "06 Jeep Wrangler X" (Great Jeep!) with a grand total of
6192 miles.
When I drive about 60 mph on the freeway, the steering wheel wants to
"shimmy", i.e. turn to the left, then to the right and vice versa.  I

Hello all.  I have a 2006 Wrangler X with 6 speed manual tranny, 3.07
gearing, and D30 front/35 rear.  I recently upgraded my tires from the
stock 215/75/15 to 31/10.5/15 BFG All Terrain T/A KO.  I am looking
for a reliable way to tell if my speedometer is off at all with the

97 TJ 4 cyl
Apply brakes at 50 mph.
Front end, i.e. steering wheel, begins to shake & shimmy....
Diagnoses?

Is it me or are the posts getting screwed up?  I don't understand why
two things I posted today (1 was a repeat) is not showing up in the
main posts, but rather in the "Active Older Posts" column on the right
side of the webpage.  How can it be older?  I JUST posted it.  Then

Heh, good one Jeff. :
Jeff Strickland wrote

grou

Heh, good one Jeff. :
Jeff Strickland wrote

grou

when my car is running, usually after it gets hot, the pcv breather
starts blowing white smoke.  what is causing this?
internet tells me the piston rings are bad and combustion is occuring
where it should not.  are there any other possibilities? (preferably

1995 JGC with the electronic heater/cooling controls (no cables/vacuum) will
not change the position of air output when selected. Air is coming from the
floor vent and will not change no matter the selection.
The manual I have (aftermarket) does not show the electronic controls or

bought a '99 TJ 4.0 last spring, have a daughter driving it, 67k miles
other than maintenance and a radio, i  haven't had to spend much on
repairs.
daughter comes home tuesday night just before i leave on a business

Hey guys,
I got a 2002 JGC that I bought new. I set the stations, seat position
and the rest and programmed it into memory position 1.
About a couple of years ago I changed the station settings and put new

my 88 yj 4.2 is not getting fuel.  ive checked the steel fuel line
that goes back to the tank. i also have checked every line between
this one and the carburetor. none of them are clogged or torn. the
fuel filter is new as well as the fuel pump.  im about to drop the

Currently I am replacing a 151 wutg a 258 w/T5/Dana 300 into a CJ7 and
seem to running into an issue. Once the Transmission was bolted onto
the crossmember bracket and I came up to take a look it was apparent
that the engine was tilted back, so much so the valve cover is resting

I replaced the evaporator core on a 2001 XJ this past weekend. The
heater hoses were old and they had to be cut off, so we did that and
replaced them with new ones. Everything went smoothly, and we
reassembled everything and started the car. Coolant started leaking