In the course of changing oil on my 1987 Grand Wagoneer, I discovered
that I could not get the new proper oil filter to thread onto the
mount.  After a dozen attempts and a meteoric rise in blood pressure,
I gave up.  After cogitating on it, I looked at the OLD filter, a POS

1987 JEEP CHEROKEE CHIEF, 4Door,4WD, 6 cyl 4.0L Automatic
VIN# xJCMRxxxxHTxxxxxx with a RENIX ECU.
Where does the Throttle Position Sensor input voltage come from?
I replaced the TPS 2 years ago and calibrated the OUT divided by the IN

Just looked at a 2010 4 door Wrangler.  We could not figure
out if the back seat would recline.  Does any know ?
Lynn

We have a 2003 Jeep Grand Cherokee Laredo, 4WD Quad, V8, that has been
a workhorse for our camping field trips.  A few months ago I had a
situation where I had a problem with the driver's side door electric
window drive broke.  When I took it to the shop, the control wouldn't

A bit of humor. :)  mostly swiped from a lot of places.
---
DRILL PRESS:
A tall upright machine useful for suddenly snatching flat metal bar stock

Strange electrical problem with my jeep...  Today, after starting the
jeep to head to work, I had to reset the date/time on my console.
This usually only happens when the battery has been disconnected.
After getting home this evening, I noticed all the lights, including

1982 unmodified CJ8 6 cylinder.
Vehicle would not start with key .. turned out to be the relay.
However before I realized that the relay was the problem I tried to
replace the ignition switch (located on the top of the steering column

A bit of humor. :)
DRILL PRESS:
A tall upright machine useful for suddenly snatching flat metal bar stock
out of your hands so that it  smacks you in the chest and flings your drink

Got a noisy lifter in my son's '97 wrangler, 4 cyclinder.   I know I
can replace the lifter through the cylinder head.  Any advice on how
to do this?  I know i will need a hydraulic tappet remover tool, and
should probably replace the pushrod and rocker arm.  I also know that

I hear there's a good "wood hunting safari" story that involves a duck.
Care to share?

My friend's 1975 Jeep CJ-5 with an unknown 8 Cyl Engine (not stock i.e.
304).
The starter starting making the horrible fingernail on the chalkboard sound.
So we took the starter off and the edge of the flywheel is ate up pretty bad

For about 2 weeks now my right turn signal has been blinking really
fast. I replaced the bulbs all around, still happeneing. The flashers
work they just blink fast, also when I put my left turn signal on,
both turn signal flash. Any ideas? Should I buy the bulb grease and

I am seeking to buy a nice restored or mint original Willy's Jeep any
body style with 4 wheel drive to putt around with.
I will also take a jeep with a snow plow too to use on my two driveways.
I will keep it as a classic and keep it garaged.

I have an '08 Rubicon that has a problem with the valve stem caps.  They are
the factory caps, but have frozen on the valve stems.  I don't want to
torque them too hard as I believe the valve stems are both fragile and
expensive to replace.  Is there any secret to removing the ...

Could anyone point me in the direction of an ARB dealer, that carries
old man EMU suspension products in the MD/DC/VA area?
Greatly appreciate it. I would rather drive for a bit and save myself
the $100 something in shipping charges.