Hi,
How od you alter the idiling speed on a 1979 Sereies III?
Thanks

the wifes saab's abs warning light is on intermittantly, if it comes
on during the MOT test is it a fail point?
Regards.
Mark.(AKA, Mr.Nice.)

John, 'tis indeed I, the one and only, ex of NLS! Still here, I'm afraid but
only for another 9 months then out! How ya doin' big guy?
Never saw your original post, just someone else's reply to it!
E-mail me off list, brianhattonatbtinternetdotcom. (New e-mail address to

Hello Brian Hatton.
                    Is this the same fellow from Falkirk and JT at RAF
Kinloss NLS.

Listening to Radio 2 today listening to Jeremy Vine.
They'd trailed the fact that Clarkson would be on today, discussing the trip
up the mountain in the new defender.
I thought this should be fun, what I wasn't expecting was the single most

Any one here owns one of the older RRs ('69-'82) running w/ Rostyle wheels?
I would like to know if they came with wheel center caps from the factory
like those newer alloy type?  (the cap says Range Rover)
Many thanks.

After a few minor problems my wife's 02 freelander started juddering again,
in the past when it has done this it has been due to a failed Sparkplug. She
also mentioned that the heater had stopped working. She juddered to a holt
yesterday. When  Landrover Recovery came out they ...

OK, so I parked the disco beside a transit the other day, and the wheelbase
looks quite feasible for 110-chassis-under-transit-body.
Question is, will anyone buy it if I make one?  
Anyone want a transit van/minibus with the off-road capability of a Land

A while back there was a mention of a new frencg roof tent in one of the
landy mags. It was a lot lighter than most others.
Anyone remember it? What was it called, URL?
Thanks,

If pasta is left in water overnight it goes soft,could that be heated up and
used, or does it need cooking in hot water?
Just a daft question 'cos I eat a lot of pasta and don't want to poison
myself.

The mount for my rear shock has sheared off, leaving a sharp rusty
stump where there should be a mount on the axle casing. Should I get a
new mount welded on, or would it be easier to replace the casing?
S111 Staion wagon.

Ok so I want to change the seal between the gear box and transfer box on my
wife's series 3. Do I just need the seal or are there going to be other
things I need? Are they easy to do without taking the gear box etc. out? Any
advice or help will be much appreciated.

i have been given a pair of shock absorbers for a land rover but any part
numer serch i do dont show what land rover they are for the part number is
ntc 8214 then followed by  land rover then 2765 0 2327 07 and finally chb
33053 can any one help identifing these and will they fit ...

in Huddersfield

A Y-Reg Series3 88" to be precise.
The circumstances of this were a little odd.
I was driving home from Milton Keynes, land of the concrete cow, and came
across a S3 broadside on on a busy bit of road.