Just placed my first order & the item (one of them) is out of stock. Are they pretty quick at getting
stock or a bit slow?
I'm after a series 3 steering wheel, washer & cap.
Nige

I made a mistake and did not take note of the oil cooler piping from the
filter housing on my ser III 2,25 petrol during my engine removal.
Can anyone tell me whether the fitting from the adaptor between oil filter
and engine block should face up or down. (can go both ways)

This is a bit of a shameless plug, but I think many
of you will find these new products of interest and/or
use....
19LHP1  Manuals CD - Range Rover Classic 1970-1985 - Genuine

I have just been told by Land Rover that my '99 Freelander with 29k miles
needs a replacement engine. This comes weeks after the cylinder head was
replaced at a cost of almost ?2000 (luckily was covered by a private Car
Care Plan warranty).

Someone start throwing sh.t at this w.nker & we'll all be happier bunnies.
I am SO glad Blunketts gone, total herbert.
Nige
--?

Lo Again
This range rover is causing me problems :(  but at least it running sweet
now, thanks for the info on the oil pump)
I need to fit new body-chassis rubbers,     its had new sills fitted

Would I be right in assuming that a 3/4 length tilt would be the right one
for a truck cab?
--
Your help is, as always, greatfully receved.

I have a 90 which has had it's engine replaced with a 200tdi. The
engine has been spewing out oil from the breather pipe since it was
fitted and I've just got it back from Simmonites who sold it to me.
They have tested it for crankcase pressure etc and can't find a

How does one start to describe this?
http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&category=29748&item=4513498277&r
d=1&tc=photo

Just a bit deaf!!
s3 steering is like nothing I have ever tried before!
I now need a manual as to tell me what the hell everything is. It appears to have 2 choke & only one of
them works!!

Series IIa, 2.25 petrol.
Is there anything required to drain the cooling system, other than
drain the rad and open the tap on the block?  I've just changed the
coolant and flushed the rad, but I could only get about 5L of new

Albert the 88" S3 is being delivered tomorrow, cant wait for a good old fashioned 'freeze my nuts off'
session to have a good look round it tomorrow!
Better get some EP90 & engine oil then! Speaking of engine oil, would you recommend some high mileage
type engine oil for the 2.25L ...

Likely cause the sender unit, if so where is it?
Or could it be a knackered gauge?
It does flick about driving, but that could be the road conditions!
Nige