Anyone had experience of the county conversion transits?
do they have a low range box like a landy, or not?

Can someone tell me the part number for the radiator top hose from the
engine. Mine is weeping slightly and to be safer I'm going to replace
it. And I'm sure Richard will tell me that I can get it from him.
The vehicle is a 1998 defender 110 TDi 300.

Does anybody know if the UJ 's on a Series One 109 rear propshafts are the
same as  on a Series 2 rear propshaft?

I was fortunate to find  one of the dual temp/oil pressure gauges, but
I'm stumped as to where the oil pressure fitting connects. It may
matter that it has a spin-on oil filter adaptor.

I'm about to start looking for 4 wheeled trailer that will be able to
carry a vehicle up to a 110 size/weight.
It'll be towed by my 300tdi Discovery.
What should I be looking for when I find one?

Can anyone advise whether the oil level in Ser III filter is supposed to
spill over into the inner ring through the small holes and be the same level
as in the outer "ring" of oil.
Any quick response so I can close up and carry on would be appreciated.

Thinking of re-painting the 110 when I finish doing the jobs etc.
They did early 110's in a mid/light green. Does anyone know what it's code is or what it's called?
Ta
Nige

two months into looking for a good solid disco we went to look at one
tonight which on first appearances looked very good,that was until I opened
the rear doors and found bubbling rust at the top of the wheel arch, looking
underneath the arch on one side I found a small hole on ...

Right, just ordered a new back door & gubbins which I'll do over the weekend.
The first job that looks a tad unpleasant is the channel that runs just behind each sill, they are
attached by what look like bolts to the door frame. The door frame is in good condition with no rust I

A modest but solid starting point
http://freespace.virgin.net/ian.cvt55/webx.htm

Alfie is getting a new coat.
The bit that was most recently dinked has a layer of paint that is reacting
with the primer filler I've used.I wiped it clean, rubbed it back and tried
with acid etch primer just for effect and the same reaction occurs.Its best

Hi all, I read somewhere on the internet that there's a kit available for
around £800 to convert the entire front end of a 200tdi Disco to that of a
td5 lookalike. Having decided to go ahead with this, I can no longer locate
the site, or any other site that sells the conversion ...

I have a 2001 TD5 DiscoveryII with a Tow bar and single socket for trailer
lights, and am in the process of buying a caravan.
As long as I promise to only tow it between 0100 and 0500 in the morning,
could someone answer my question?

Please help:
I have a 96 Discovery, 4.0, AT, NAS.
While traveling down the highway at 25 MPH I heard and unsettling noise from
the rear. I immediately hit the brakes and threw the car in neutral as the

I need to source a "Mr Softy" type ice cream factory.  I'm having a
garden party in July (finally getting married) and i want to lay on
ice cream for the guests.  Without buying an ice cream van, where
would I hire such a thing?  Google isn't helping...