I need to replace the front (and while I'm at it, rear) UJs on my 1989 DT
90.  However, I'm lead to believe it has a '97/'98 chassis but with the
original chassis number stamped into it.
Can anyone recommend a Part # for the UJs I require, as I believe a '89

Anyone know?
How much do they cost?

I used to have a 3.9 V8 classic and sold it a few years ago, I am now back
in the market fore another one.
The question is, which is the best way to go, another V8 and get it gassed
to reduce running costs, or buy a P39 diesel.

Well, gone and done it, bought an N plate 2.5dse in Niagra Grey. The only
thing is there is only one key. Is it easy enough to get hold of another one
or is it a big problem.
TIA,

Hi Richard, have you got an airflow sensor for a discoII V8 yet? Notice your
website says it's pending? (ERR7171)
Cheers,
Badger.

Turns out that my leak is a lot more serios than appeared to be the case, a
cracked cylinder block therefore a new engine.
I have just picked up a hire car, and now I know why I will not go back to
anything ordinary after landies,

while changing the oil and filter on the SIII, I noted that in the bottom of
the oil filter housing was a spring.  The only purpose I could see for this
is to press the filter element up against the mating flange at the top, and
indeed without something to do that, the oil can ...

I have a 1990 defender 200 tdi and on my way back from malvern lro show
yesterday , managed to use 10 ltr of oil in 200 miles, any ideas anyone,
there is smoke and pressure from the oil filler cap and dip stick, i have
been told there could be a hole in a piston or cracked rings, ...

A few years back I saw a garage / car cover which was like a U shaped tent
you drive up to then pull up and over the car to form a tent. Any one know
where one can be purchased?
This is for a mucker at work.

I had my bonnet-mounted spare off today to replace the tire.  I noticed
that the mounting plate isn't well attached to the bonnet -- about half
the rivets have pulled out of their holes.  I was thinking of replacing
them with either stainless or brass screws.  Any caveats or ...

Evening all
If anyone wants to share expenses to Sodbury from Yorkshire (well
Harrogate, Leeds and close off the M1 to be precise) this October drop
me a line. I will have a spare comfy seat and space in a van if anyone

I want to replace shocks and springs on 1995 Disco 1 V8i ES but there are so
many to choose from!
Not used off road (not in the way you mean!!) but do tow a couple of tons
everywhere.

For best results, please read this posting whilst listening to:
http://www.101fc.net/files/soap.mp3
So, the show season is nearing the end... or not so.  
September hosts three shows;

Just had my series 3 serviced and she's come back with a problem she didn't
have before. Turn the ignition against the spring to get the glow plugs
working, and no orange light. Thought it might just be a dodgy lamp, but
whereas before she started on the button, with no delay, I now ...

Good Morning.
I am getting a gas conversion done soon on my 2.6 litre 6 cylinder series 3,
but the mechanic i have enlisted to do the work is having a little problem.
He can't seem to find any mixer that will bolt straight onto the filter side