I'm after a milling machine - not high power, more focus accuracy for
making shells from coins.  The type of thing I'm after will machine
out a 2p so I can fit a 10p in it.  (This is an example of the
accuracy I need, not the actual application...)  Erm, if that makes

http://news.bbc.co.uk/1/hi/health/4315784.stm
sigh....
If you're gonna get run over...you're gonna get injured whether it be a 4x4
or a normal car.  a 4x4 driver is more likely to spot the idiot pedestrian

I could do with a proxy-look at a lathe I'm interested in - too far for me
to go on spec and too old to buy without at least some indication that it's
in good nick.
I'll be quizzing the seller but he's not especially savvy about lathes by

Put a new set of Michelin  Synchrone tyres on my Freelander ( '98 i -
petrol, wagon ) about 20,000 kms ago...but now they are back to the previous
road raor I was getting before ! It's really loud on the freeways, even if
just coasting with the clutch in, and engine idling..

Either fully glazed or just the frame?
I think Beam-ends will be along shortly...................
Nige

Last week my 4.0 litre RR engine completely died on me. It's an R reg and
all tied in with the engine block becoming porus (due to Landrover screwing
up the way the engine was made) as I have had loads of over heating problems
and it was drinking coolant like George Best drinks ...

For project Launch Rover to get my boat in the water I have blagged a set of tyres off a Manitou, but they require the above size rims.  Used to own a 101 but can't remember if the rims on those were any larger than normal.  Can you get 20" rims to fit Landie hubs, I'm not too ...

Do Landrover Make A Factory Disco 3 Commercial ?
Regards
Jb

All,
110 Defender CSW 1990 2.5l diesel (just pre 200TDi)
This should be simple - but as ever it aint!
I have a problem that with the fuel cap fitted (it is the correct one I

I have recently got a 2004 facelift Disco Landmark, which unfortunately has
come without either the Owner's Handbook or the radio code.  I am trying to
get both the code and handbook through my dealer, as until I get the code I
can't fit my Discoparts cruise control kit (or if I ...

Hi all, do and have all the Land Rovers ( series and 90's / 110's etc ) had
their bodywork made of the alloy or is it just ally these days. Can you buy
sheets of Bermabright from sheet metal stockists
Rich

I have been working on the rear brakes of my 1997 Tdi300 Defender 90.
The rear brakes have caliper, not drums, which are seized and will have
to be replaced. OK so far.
The front brake shoes are held in place with two pins that go through

I have had an annoying sharp clunk that seems to be from the front passenger
side of the 90. I cannot find any loose suspension or steering components. I
have recently fitted a complete polybush kit (a fun weekend!) but the noise
persists. I was told by more than one person "it's ...

Couple of yoofs outside earlier looking over Grumble as I returned
from walking the dog...
Lots of 'tight' comments along with 'baad' (which apparently all means
'good'), followed by; "It's an old UPS delivery van, isn't it?"

Anyone experienced a squeel from the turbo - occurs most when cold or when
pulling (sounds like the fan-belt slipping)
I'm told by a Land Rover mechanic that it's the turbo - he then followed
with tales of woe should the bearing collapse causing engine damage - or