Another minor, although annoying problem.
Range rover interior lights have a mind of their own. They come on and
sometimes go off, sometimes (more frequently now) stay on. My first
port of call is going to be the little "plungers" that show that the

How many weeks to chrimbo folks?
Right, now I've throughly depressed all of you time to have a group
hug and discuss small tools that are a god send.
Like earlier today I was tightening the rocker covers on the Disco,

Here's why you DON'T use an angle grinder near a charging battery...
http://www.cbmsys.co.uk/photo/dsc00031_small.jpg
Alex

Hi Group, I have seen a 110 diesel nonturbo with hard top and towing gear.
It is obviously ex-MOD and has been very badly painted. It is C regd and
going for £3500. Is that a reasonable price or should I look elsewhere?
Thanks for your replies/insults!

Fellow listers Hi,
could someone please advise me of the proper oil pressures readings for the
3.5 (low pressure, carburator) and/or 3.9 Efi engines when idling or at
around 2000 rpm.

Does anyone know: if I buy a used Series I or II Discovery without the
third-row seating, can I add in the two seats from a wrecker? The five
seaters are a lot more common but we'd like the facility to carry 7.
Regards,

I need a good sparky to advise.
Does the vehicle polarity (my dynamo based 2a is +ve earth) matter when
fitting a voltage regulator? These items are a closed book to me i'm afraid.
Electrical things beyond where the wires go onto the spade connectors all

Is REDEX diesel additive of any use.  I understand it
keeps the injectors clean.  I have a 97 Disco TDI
Your thoughts would be appreciated

My 94 Rangie ran low in rear diff oil recently. It now has a droning noise
that my non landy mechanic believes is the diff, and he tells me that a
landy mechanic checked it and it is really not to bad.
It has an occasional clunk and vibration now when hot, at times this is

Take plenty of pics & next time I'll be there. Working all weekend this
weekend after 65 hours already this week!! ;~)
'We can take it'
Nige

Ok calm down not that type of strip, is there a website about that details
stripping down a Landy to the chassis before I go nuts and buy that 110 ( I
think I taped that Mark Evans project but for the life of me I cant find
it ) I just fancy a little light reading (cough) to put me ...

Just in relation to the mounts on series gearboxs, will a 4cyl gearbox bolt
straight into the transmission mounts on a 6 cylinder chassis? because the
gearbox is mount a couple of inches back on the 6 cylinder, is this achieved
by different mounts on the chassis or modified mounting ...

Well done Marc, it was a split turbo boost diaphragm!
I also had a new set of injectors fitted and to celebrate I'm now
running on my first load of bio-fuel!
Cheers

Query:
Will a Landrover 2.5 N/A diesel engine install into a Series 2A with along
with original Series 2A gearbox?
Regards,

Parcelled up and ready to go tomorrow.
Been doing a bit of housekeeping and realised I've got too much tat
;0)
Lee D