The manual says "tension with a lever-type torque wrench to 20Nm"
Is that right ? It sounds like bugger all.
Steve

Perhaps someone could help me out, with winter coming on I have
realised that my heater blower is U/S (110 CSW). I have traced the
cables out and I am a bit confused over the purpose of the resistor in
the top of the unit. I have 12v going into the motor unit and I can

A J reg, 200 tdi 90, good price, checks out on insurance, reg number brings
up details, Checks out on the DVLA vehicle info, and the RAC one.
It has no history, just MOT and logbook.
Gonna try and get to have a look sometime this week....

I've replaced the front pads and need guidence ob how to properly bleee the
lines.I've had someone pump the brakes and hold them down why I crack the
line open to release the air and I've done this at the calipers and the
master cylinder also(which does not look like a typical autos ...

Can anyone offer me some advice please?
I have a 2000 Discovery TD5. It has done around 53K miles.
When accelerating air can be heard travelling through the heater matrix
behind the dashboard.

in to temptation :0)
http://makeashorterlink.com/?Q26F2152C
This one is particularly close to some of our Welsh contingent and has a
drop plate to tow a caravan ;0)

Well I couldn't hold out any longer buggerit
ebay item 4587828586
Derek
(thats another one off the list)

Anyone got one of these lying about? If so, could you take a quick
measurement for me?
I need to know the distance from the pulley edge to a reference point
(doesn't matter too much which one) on the mounting bracket.

Tomorrow will be the start of Morphs reasembly. When I reinstall the valley
gasket do I use any kind of sealant around the rubber seals at each end or
just use them naked? Just a thought.
3.5 V8.

I have a whining noise from the transfer box at around 30 -35 mph.in a '95
Disco. Has
anyone used any of the additives Wynnes or Molyslip to quieten a similar
noise? How

Iv'e seen adverts for 'sankey' trailers at decent cost (£150-£200 etc) They
look very solid to me & look to be able to take a whole load of crap! My
towbar has a ball & socket thingy, it does however, have a drop down
pin/bolt type fitting too. Is this compatible with what, i ...

Hi all, I have the stock 205/80R16's on my '92 D90. I would like to use
my vehicle to a lot more greenlaning, to get to work safely in all
winter conditions, and also to go on some of my own land. I have looked
through the mags at tyres and it seems the BF Goodrich AT KO's are well

http://cgi.ebay.co.uk/Ex-Northern-Ireland-Armoured-Landrover-Piglet-Pig_W0QQ
itemZ4587512402QQcategoryZ29748QQrdZ1QQcmdZViewItem
You have to imagine it doesnt need any additional security measures for on
street parking. I like the sun roof  with the interesting mount I suppose it

I've been going over my landrover checking out all the oil
levels.  I'm a bit puzzled by the swivels.  In my Haynes
manual it shows a 'level plug' and a 'filler plug'.  However
I can only find a single square-section headed plug on

I've Changed the front brake pads Now my pressure is low and the brake peddle
is mushy and goes to the floor and strugles to stop the vehicle.I can't
figure out how to properly bleed thew brakes.PLEASE HELP  THANKS ERIC