| Thread | Last Post | Replies |
|
| Defender / Series hard top compatibility? | 19 Apr 2006 21:58 GMT | 2 |
Will a Defender 90 hardtop + rear door fit onto a Series IIA or Series 3 SWB truck cab? If not, why not? (What's different??)
|
| Looks like a pleasant summer... | 19 Apr 2006 21:58 GMT | 7 |
http://uk.news.yahoo.com/18042006/344/summer-fuel-prices-set-spiral.html
 Signature Regards Bob
|
| p38 wont start | 19 Apr 2006 20:49 GMT | 6 |
1997 2.5DSE wont start anymore. Used to take a couple of cranks before it would start.Sent to Land Rover for repairs and they said to replace glow plugs. After replacing them, it still wont start. It only started once after replacement. Car has been sitting in garage for 2weeks
|
| Disco2 V8 4.0 cat | 19 Apr 2006 19:21 GMT | 3 |
Does anyone know the symptoms of catalyst failure?My disco seams to be less responsive and idles a little lumpy,it also seams reluctant to kick down.When i floored it this morning it seamed sluggish and when i stopped there was a sulphur aroma in the cabin.If the cats are failing ...
|
| Polybushes - Again....... | 19 Apr 2006 12:32 GMT | 7 |
Right. Spent all evening getting the old bushes off/out of the rear lower link. Ive got the new ones in, but at the chasis end, it is now a couple of mm wider at each end due to the bush. It now wont fit into the bit on the chasis as
|
| Air Cleaner Dump Valve - LR90 | 19 Apr 2006 10:29 GMT | 7 |
After around five years of ownership I discovered in the handbook the need to check the air cleaner dump valve for blockage and condition. This I attempted to do earlier today - I do not
|
| Murdering 4x4 paedophile rapist scum headlines on beeb again... | 19 Apr 2006 00:54 GMT | 28 |
http://news.bbc.co.uk/1/hi/education/4900000.stm While I'm no fan of the road-going 4x4 brigade, it's a little tiring having the daft opinions of some random teacher touted as the headline article in the entire education section. Especially with gems in it
|
| Towing a Defender on an A-Frame? | 18 Apr 2006 23:59 GMT | 11 |
Anyone any experience of towing a Defender 110 on an A-Frame? Are there weight requirements of the tow vehicle, legistative gotchas, and what do I need to add to the tow vehicle and the Landy to make it all work? I'd like to be able to tow the Defender behind the Pinz,
|
| Land Rover, Narrowstep Launch Broadband Network | 18 Apr 2006 22:15 GMT | 1 |
Land Rover, Narrowstep Launch Broadband Network LONDON/NEW YORK, April 13: Automotive brand Land Rover has teamed with IPTV company Narrowstep to launch a broadband channel, Go Beyond, covering travel, food and wine and other lifestyle content.
|
| Throttle cable for V8 with Weber 500 | 18 Apr 2006 21:48 GMT | 1 |
I've just fitted a 500cfm Weber from RPI (badged up as an Edelbrock). I'm not happy with the half-arsed throttle cable solution that RPI provide and the original cable is a bit 'snug'. Any suggestions for a longer cable (with a 'eye' fitting at the pedal end
|
| SRS problem | 18 Apr 2006 20:34 GMT | 3 |
Hi there everyone Just got my 95 disco back from the bodyshop after some careless driving (mine). Now the SRS warning light(s) are permanently on (the ones in the middle of the tachometer). They had obviously disconnected the battery at
|
| 300tdi hard to start | 18 Apr 2006 20:12 GMT | 8 |
I have a 300tdi auto '98 and it has been getting worse and worse to start lately. To start it now it has to be cranked for a few minutes! It started off with prolonged cranking from about 10 secs now it seems to be getting longer
|
| 96 Tdi ZF auto box isues | 18 Apr 2006 19:14 GMT | 2 |
Hi all Following Pantellis comment about the virtues of replacing the gearbox oil several times and cleaning the filter, I thought I would have a go this weekend.
|
| oil leak 300tdi | 18 Apr 2006 18:56 GMT | 7 |
Just discovered a small leak from the front of my 300tdi. The oil is leaking onto the axle at the front - suspect either front of the sump gasket or front crankshaft oil seal(if it has one)!!! Remember reading somewhere that there is an oil seal that is changed when
|
| HELP w/ Panhard OME Poly Bushings? | 17 Apr 2006 23:37 GMT | 1 |
Maybe I did something wrong but I highly doubt it... You be the judge. I had a shimmy at 45 MPH which would go away at 50-55 MPH. I tracked it down to the panhard rod being loose at the frame connection. I opted for an Old Man Emu panhard rod poly set for a '96, Discovery, 4.0L.
|