Having been really pleased with myself for fitting power steering to my 1990
90, some of the shine has started to wear off.
Over the past couple of weeks, the steering has gone from being smooth and
effortless to being distinctly 'lumpy'. As you turn the steering wheel from

Morning
Im going to change the speedo pod on the range rover today, with the one
i bought at Sodbury - Last time!
My rangie has about 80k on the clock, but the new clocks only about

I suspect the arrangement of battery negative wire on my 109 (12V negative
earth petrol) isn't as it was intended, there is a wire from the battery
terminal to the bolt on the side of the engine that holds the bracket for
the crank case breather, and nothing apparent linking the ...

Just tried to purchase a RHS wiper blade for the Disco, but both the
Halfords own and the Bosch are too wide in the middle to accept the clip
that attached to the wiper arm.  The OE blade has a very narrow centre
section.  Do I have to order one up from a main dealer, or is there ...

Does anyone from this group read the S2C forum?  Having posted stacks of
stuff there when I was sorting the S2a, I now find that my account has been
cancelled and I don't exist!  Forum admin isn't answering his emails.

On my stage 1 when I go round a corner I get a Clonk from the rear ,
the strange thing is if I go round a right hand corner and it clonks I
will not get another one until I go round a left hand corner no mater
how many right hander i take after that , I also get no clonks or bangs

Have I missed any mention of this on the ng?
I'm a newbie for this event - is it worth the journey?
cheers
Peter

Dude the forum has been down two nights running. Do you need a bigger ammer?
I'd guess that it's in hand , or you've worked out my shift pattern ;-)
Lee D

http://news.bbc.co.uk/1/hi/business/6062084.stm
Are there actually any British made vehicles left?
Lee D

My 2001MY Freelander has a nastly little habit when parked with the
handbrake on after heavy rain/pressure washing.  The rear brake shoes
appear to stick to the drums, and a little rocking backwards and
forwards is required the next morning to free them off (with a loud

on a 3.5 hotwire disco V8
Anyone had any joy with lubricating these?
It seems as though the one on the V8 here is a bit lazy - it does respond to
increased engine load, but not as fast or as much as I'd expect.

I have been informed that my injector pump on my '86 110 N/A County is
on its last legs, I've seen a few 2.5TD Injector pumps on ebay, anyone
know whter these are the same ones? I have the 'DPS' type apparently.
Alternatively, anyone know of someone breaking a 2.5 N/A engine? Having

I have got a series2A and i have had trouble with the fuel gauge or sender
since i've had it.the gauge would only read either full or empty or when
the
fuel level got low it would bounce up and down.

Hi, can anyone point me in the right direction for instructions on how to
install a soft top on my series 1 . I`ve got all the bits including the
`sharks tooth` but my screen top isnt drilled and I`d like to get it right
first time rather than bodge it .

Disco Series II V8i 2002:
Intermittent (and so far untraceable) water leakage into the driver (RHD)
footwell is becoming exasperating!   I just can't trace it, and hesitate to
rip out all the centre console and carpeting etc.