It hangs down so low it is going to get trashed off road so can I just cut
the back box off and put an exhaust finisher trim on or will it be too noisy
and illegal/MOT fail without it???

Is there anybody on the list who is travelling between the Gatwick
area and Wiltshire in the next few weeks?  I'm just seeing if a cubby
could be moved my way...
Cheers

It's a 1994, 300tdi Auto, with twin air bags, MA648***
The SRS light flashes for a few minutes, then settles to steady on.  The
battery had gone a bit flat after a few weeks non-use, I'd started it
with a magic yellow box, then charged the battery overnight with a cheap

My 90 has always had a really hard clutch, which is something I accepted as
part of its character. The problem is that a fall off my bike seems to have
left some slight damage, which means my leg hurts occasionally after I use
the Landy in traffic. It looks like I'm not the only ...

Crankshaft Pulley nut on a 2.5ltr petrol (1987), is it 40mm?
And, is it normal thread or left handed thread?

On a "P" reg TDI 300 is the near side and off side individually fused
I changed  my rear off side bulb because the stop light wasn't working
Now the stop light ok but I've lost my near side light back and front
If it is which and were is the fuse

Some time back, I had a leak in the passenger side air spring, which caused
the motor to descend overnight.  
Now it's doing it on the driver's side, but not all the time.  Just now, I
parked it up and it'd gone all the way down in abotu 2 hours, and in town

I was wondering why does my TD300 (all diesels?) need a vacuum pump
for the servo when pertrol engines don't - I would have thought that
the vacuum on the inlet manifold would be much the same on both. Can
someone enlighten me please? Is it because of the turbo?

The part needed to make my car roadworthy again is £15, they aint got any so
my car is off road until the 28th of this month?
f.cking pathetic.

OK, it turned up this morning.  Convincingly tidily made loom which
intercepts the plug to the injectors on the front corner of the engine, pity
about the silly in-line fuse holder, would be a neater job to put a
fuseholder in the unit itself, I'd've thought.

Hi gang. A few weeks back I noticed that my 1994 P38 Range Rover HSE was
losing water. I took it into my local specialists who discovered it was the
seals to the heater matrix. These were replaced but it was also neccesary to
replace the matrix too. I collected the car last ...

ISTR that yuo need the wheel switches, the one on the dash and a bit of
wiring inside the wheel...
anyone got a source to buy the whole set for a good price?  They used to be
on fleabay, but I can't see any now, nor any others online.  I'm sure there

I'm looking at swapping my Disco 300tdi off roader for a Defender 90 TD5,
the one in question is a really nice example of a station wagon on a 1999 V
Plate and is a good price at £6250. Only concern is that it has done 125k
miles and has no service history. The chap selling seems ...

Am thinking of getting one for my 300 tdi 90 and wonder if it is really
worth spending the extra on a Mantec (£200 plus) as opposed to the
alternative "opens with rear door" version for just over £100
Views/advice would be welcome

Hi all, I have a few scratches on the Disco from green laning.  Looked
lovely when we first got it but a few years of off-roading and it's now
looking quite tired, see pics .. the scratches are everywhere including
the roof, some down to primer, a couple down to metal.  It's been ...