| Thread | Last Post | Replies |
|
| How long should a battery last? - storage advice? | 17 Dec 2004 01:22 GMT | 8 |
Just gone to get my 2002 MX5 1.8 out of my garage. Battery too flat to start it. Hasn't been used for 2 weeks and only had one short run in the 2 weeks before that.
|
| I know this has been asked, but... | 15 Dec 2004 05:24 GMT | 1 |
Has anyone experienced a battery drain even after disabling the radio (aftermarket)? My '91 has an issue with holding voltage. A new battery was installed this summer after some alt and bat testing. The alt tests good, but even the new bat won't hold voltage for more than two ...
|
| Where's the cheapest place to get shifter boots ? | 15 Dec 2004 04:53 GMT | 2 |
I need the small, and large rubber boots for my NA, and I was shocked to find out how much the dealers want for them !! About the best price I've seen so far is from Trussville for ~$48.00 !!! I think it's nuts that you can buy a CV boot for $8.00 but a shift boot is
|
| Anyone here in Melbourne, Australia? | 14 Dec 2004 22:30 GMT | 1 |
I have a 1990 MX5. The custom exhaust is rattling and giving me the sh.ts depite numerous attempts by my performance mechanic to silence it. I was wondering whether there were any Melbournian readers here who could
|
| Airbag Indicator Light | 14 Dec 2004 18:57 GMT | 3 |
I have a 1992 Miata which I bought new in November 1992. It now has 7000 (seven thousand) miles on it. Within the last month, the airbag light has started to flash. The blink rate is four flashes on at one second intervals then off for four or five seconds. Then the cycle repeats ...
|
| hub centering rings: plastic vs. aluminum? | 14 Dec 2004 18:40 GMT | 16 |
As I was putting on my 3rd snow tire this morning, it dawned on me that I needed centering rings for the aftermarket wheels that my snow tires are on. Some places sell poly carbonate rings, some places sell aluminum ones. Since they're supposed
|
| Bad oil pump?? | 14 Dec 2004 12:25 GMT | 9 |
My '92 Miata with about 90K, has been pegging the oil pressure gauge at the 90 psi mark during acceleration. Thinking it was the gauge or sending unit, I took it to my mechanix. He said the both were fine and the oil pressure was actually in the 70-90 psi range at 2500-3000 rpm. He ...
|
| Ford Focus SVT as replacement for Miata: your thoughts | 13 Dec 2004 14:31 GMT | 16 |
After so much enjoyment, I have to consider another vehicle. I'm almost sick thinking that my Miata-ing is either limited or over now. I can't even count the good times I've had with it. My '90 first-month-of-production is at that point. The tranny failed
|
| NB howl! | 12 Dec 2004 21:10 GMT | 12 |
Dear MX-5 aficionados, I just bought my second MX-5 a couple of weeks ago: this time a Grace Green1996 NB with 90.000 miles and a full year of warranty that I bought from a Mazda dealer here in Belgium.
|
| 1991 red turbo report | 11 Dec 2004 21:59 GMT | 5 |
The 1991 turbo 1.8 liter that I bought is still going well, car & driver are both alive and uninjured. I have been driving it very carefully, almost re-learning to drive the car. I spent 5 years with the ability to give my miata near-maximum to maximum acceleration under almost ...
|
| Heater core link | 11 Dec 2004 20:39 GMT | 5 |
The '90 blew out it's heater core today. Someone posted an article showing how to remove and replace the core without pulling the entire dash. I sure would appreciate someone re-posting that link. Thanks,
|
| carfax | 09 Dec 2004 16:02 GMT | 2 |
Can anybody please run a carfax history report for the vin number knadc123626196853 Thanks, Prajwal
|
| How to remove screw from hardtop? | 09 Dec 2004 03:02 GMT | 7 |
I had to remove the front latches from my hardtop so I could replace the plastic "bullet points" that seat into the plates at the top of the windshield. One of the latches came off and went back on without a struggle, but the other was almost
|
| 93 rx-7 question? | 08 Dec 2004 12:30 GMT | 2 |
Have a gas smell that's getting stronger since I 1st noticed it coming from the engine a few weeks ago. I see no drips underneath the engin and the feul gage *seems* to be on target for gas use. A new after market intake and outtake was put in about a year 1/2 ago. Drives fine... ...
|
| Best roll bar for head clearance? | 08 Dec 2004 05:03 GMT | 9 |
I posted this same question on Miata.net, but I'd like to get some input from this board too. I've read several threads on the topic of rollbars, but I'm hoping to find a more definitive answer.
|