Let's not start theTurbo vs. Supercharger argument. I have a '90 1.6L that's just getting broke in good and I have finally desided to bite the bullet and do some forced induction. Can I hear from the folks that have experence with turbos especially the GReddy kit?? Tuning ...

I've been a very happy owner of my Miata/MX5 for over a year now, but
it has recently been causing me some problems, and I am after some
advice/help.
My car is a 1991 model 1.6i

The air dam on my '99 is pretty scratched up, and I want to get it painted.
My question is; would it be cheaper to have a body shop remove it and paint
it to match, or should I just buy a new one and bolt it on?  A new, painted
air dam is $249 shipped right now.

I am about to purchase a replacement (ebay) for my second keyless entry
remote.  The specs match up completely and I'm not even certain if it's
a MAZDA part or an aftermarket one.  Anyway, how easy will it be to
program?  When I enquired about replacement about a month ago, the

 just barely flunked ca smog test due to slightly -- very slightly --
over-the-limit nitrogen oxide at idle (while o.k. at 25 mph). the technician
(it was a "test only" facility) said he suspected the oxygen sensor needed
replacement. everything else tested fine. any other ...

Nice shiny red, 5 spd., hardtop, rollbar, looks stock.  Here's what
really caught my eye...one owner with only 78K miles.  It's six miles
away, I'm going to go check it out later this week if it's still for
sale (sometimes auto trader listings get old!)

I have a 2000 Mazda Miata.  I see references to MK I, MK II and MX-5.
Can someone tell me what the differences are?  And if they would know
what I have (i.e. can you tell by the year or is there other
differences).

I have a 1983 RX7 with a good running 12A rotary engine and a good 5 speed
transmission. The doors are straight and rust free, no bondo. All the glass
is good.Everything works The rest of the body is beat up, especially the
front end. It was involved in a minor collision. In my ...

im looking for 12a and 13b porting templates if anyone out there could
help.
thanks

   Like the subject says, the battery died, I changed it, between the time
I also shorted it by jumpstarting it with the cables set wrong.  Anyway, I
bought a 100AMP fuse and fixed that part.  But now, the car starts and works
fine, all the dashboad lights work fine, but the ...

I am replacing the standard 14" 7 spoke hollow wheels on my 94 Eunos, after
one too many bumps have caused a buckle.
I really fancy the OZ Records in 16" with 205/45 section tyres. I cannot
find any weights for the OZ Records at all, from many hours surfing, but

After 4.5 years of suffering with a trunk rack for my mountain bike, I'm
ready to take drastic measures to get a hitch rack on there so I can access
my trunk with the bike on the car.
My problem is a regular receiver hitch won't work...  My driveway slope is

I am thinking about taking over smb's lease
for Mazda MPV . There is 15 months left,
and I don't know yet whether I want to
return the car at the end or I would buy it out.

Anyone have a link to where I can find some carbon air dam protectors?  I
found them once while surfing around the internet, but for the life of me, I
can't find where they are now.  There were little carbon fin bumper
thingie's that bolted onto (underneath) the two front corners, ...

When instaling the lower shifter boot (the small one) I couldn't decide
how far to slide it down on the shifter.  I slipped it over the top
part and then it popped onto the part where the shifter goes from being
fat to being skinny.  There is a little groove there that the top of