As predicted, approximately 3 to 4 hours to replace a $10.00 part. I
could have gotten away with about half the cost and saved maybe 30
minutes, but I decided that replacing the other two fuel lines was a
good idea while everything was apart.

http://www.sun-sentinel.com/sfl-0325carjacking,0,2861462.story
"...He pushed Lapierre out of the way, grabbed the keys and jumped into
the Nissan. But it was a manual transmission and Singleton couldn't
operate it..."

The new range-topping model will be based on the RX-8 RS that has
leaked on internet sites ahead of its debut at January's Tokyo Auto
Salon.
The RS itself adopts subtle visual enhancements on top of the RX-8's

I've been running Falken Ziex-512s on my '97 daily driver through two
sets of tires and have been happy with them.  Now I see that they have
been replaced by the Ziex-912s.  I did a quick search and found
several comments stating that the 912s handle very poorly due to

I have a '03 SE, of course with the 6-spd.  I'm replacing the trans and diff
fluids with Redline.
Through past postings and emails, I've determined that MT-90 is for the
trans but haven't seen what to use for the diff.  Suggestions?

Need to replace tyres on my 94, currently with standard 14x6 rims, fitted
with standard 185/60R14s. I would like a set of reasonable street
performance tyres, but I can't find a single manufacturer who lists
195/55R14 at all!  I am in Australia, but most major brands distribute ...

I pulled into the driveway and thought that I smelled a strong gasoline
odor. I left the engine running, popped the hood, and saw gas literally
spraying all over the fuel rail area.
A quick jump to the ignition key while being thankful that I have made

Starting to get some cracks on the side of the top, where it folds
down.  Was wondering if there was some kind of glue or silicon that
would work to seal/batch it up.  I do not want to replace the top at
this point but don't want it to get worse.  thanks.

about 2k miles ago, i rebuild the tranny,(costly mistake, should have
gone used), old jrsc, and motor on a 95M-ed w/ a jrsc.  the machine guy,
(excellent reputation and I have used him before), disassembled the
reciprecating mass  did various machining, (10 over) and reassembled ...

http://www.leftlanenews.com/mazda-planning-mx-5-coupe-for-the-us.html
--

Folks;
I'm having a problem with automatic transmission fluid getting into my
cylinders and burning. It happens only occasionally, but in reading
about other cars, the advice is to replace the "modulator valve".

Any opinions on this: http://store.miataparts.org/mibealunpa19.html
I have the original plastic/cardboard/regurgitated-compressed-yakfat
thingy which is pretty well shredded.
I'm sure I can find better uses for $200 such as a couple of gallons of

the window gaskets on my 95M get pushed up and bunch up at the top by
the windows.  i thought about gluing in place them but figured that they
would end up tearing if I did that, so anyone have a good solution for
this problem>

Getting resistance while opening door. Should I use Lithium grease?

Hi, I apologize for the length of this message but I wanted to get all
my thoughts in one post.
I have a '90 Yellow Miata with 95,000 miles and going strong here in
the Northeast US.