Motor Runs but no pulleys or belts are turning . Where do I start to
fix this? Help  on this will be GREATLY appreciated.--NW

The suction function (assisted door locking function) stopped operating for
the driver's door and truck.  Any advice on what could be the cause for this
failure and how to fix it?  Thanks!

Have an '81 240D with only 117K actual miles. Problem is the rear of the car
"dog walks" down the road to the tune of about 5 or 6 inches to the right. I
've check to make certain everything is tight but when I place a straight
edge on each rear wheel it always points to the right. ...

I need to replace the LF window regulator in my 124 bodied 300D.  I found a
regulator and motor unit and wondered if I can do the job myself.  Is there
anything I need to know?  Is the door panel difficult to remove?  The
switches for the seat adjustment pose any difficulty?   ...

I am presently looking at and comparing two 1986 560sl 's and have a
question...
One of the cars has the center high mounted stop light on the back edge of
the trunk, the other has the light near the leading edge of the trunk, next

car was runnin fine i parked the car came back after few hours i wont
start untill i press accleater when let go accleater i would shut down
i dont wat happa wat is goin on the i didnt wana start ma car at all
next day it wont even start even i press accleater i dono wat to do

I recently received an email from MB introducing the 2005 E Series, but
not much detail was provided.  Has anyone heard of any signigicant
differences in the new model?  Will they still have the computerized
steering, brakes, and throttle?  Hopefully they will make some software

Anyone seen this?  More to the point, anyone know the fix or some
possible fixes?  The problem started out intermittent, but now it will
never start in PARK.

does anyone know of a good service provided in the Minneapolis area?  I want
to convert my 380SL from R-12 to R134 A/C  I can't afford to take to the
dealer who wants a fortune.  Thanks

Any input on new s types    Frank

Just finished replacing O2 sensor, cleaning, and regaping plugs (less
than 1000 miles) distributor cap and rotor,         Big, Big change in
pep and drivability.        1992 2.6 still has a stumble after starting,
raising idle speed smooths it out. Suspect leaky injector seals.  At

My '94 SL recently developed a groan when the driver's door was opened or
closed (arrrgh!)... the cause: broken ear tangs on the door-check assembly.
Rather than confront an expen$ive repair bill from MB, I decided to try
tackling the problem myself (I was a gearhead in an early ...

http://bushlies.no-ip.org
The latest neocon lie involves Kerry's use of the word 'sensitive' to describe
the war on terror. Once again, his remarks have been taken completely out of
context. In fact, the same argument Cheney is making about Kerry, Edwards could

One a tha last thangs Hanz und Franz told me at Heavy Karls was thet ah had to
have them pull the intake manifolds to grind off the carbon to get the engine
warning light to turn off. And it would only cost about $1500. So smilin sam
and tha boyz sort of laughed, looked at the light ...

The keyless remote ( Knifeswitch type ) stopped working
Batteries good ----  Light not blinking when held for more than one
seconc (a la manual) Question is can the bulb be replaced or does it
rarely go bad