I have an 85 190E that needs a new driver's seat belt receptacle (the
piece that the belt clicks into).  There is a plastic piece inside
that secures the belt that is worn out.  I replaced it a couple of
years ago with a used one I bought from a parts recycler I found on

I want to connect my laptop to my SLK '97 to analize data while moving
and in my garage.
I have a lot of software to read the eeprom and other data.
I have :

I'd like to upgrade the analogue phone that came with the 95 SL320 to the
new cell phones. Is there a way of doing it where hands free module in the
dash is still utilized/used instead of replacing it? is it just a matter of
replacing the cable that rans from the cell phone (hidden ...

The window regulator on the driver's side is busted on my 86 300SDL -- several
teeth are missing so the window does not go all the way up.  I ordered a new one,
but am wondering how easy it is to replace the regulator.  My mechanic says
to do it myself because his time is ...

What connection is there between the vacuum system and the ac that would let
the air stop blowing out into the cabin after about 90 min running on the
interstate highway system at continuous speed of about 65 to 75 miles/hour?
Shoud such a device have been replaced when the ...

It appears that I have a AC R134 leak at the evaporator. When inspecting
with an UV lamp I found traces of the dye at the drain tube from the
evaporator housing . Are the odds that the evaporator itself is bad or just
the connecting hoses at the evaporator? I was able to get my ...

I just bought this car and absolutley love it except...
I expected a roadster with a V8 to absolutley give me whip lash when I
floor it.  It is slugish accelerating but ok at the higher speeds.  Is
that the way they are or what should I be looking at?  Also, the AC does

I am looking for an oil cap for my 1964 Mercedes and would like some
help locating some places here in oregon that would have something like
this.
Any help would be greatly appreciated.

I recently purchased one. Right after startup for 1-3 min when it is all
right, then for about 10-15 min until it warms up till 80 degrees C it
does not really want to accelerate - pushing the gas does not change a
thing. Ater that it runs fine.

I pulled  the dash in my 83 380SL to check the speedo cable: there wasn't
one. My $24 chilton doesn't show the cluster in detail. where is the
sensor -sensors?( need diagram??) Jim

For those of you who have the misfortune to own an ML that has a notchy gas
pedal feel, there my finally be some hope.
I took my 2001 POS ML 320 to the dealer for it's quarterly repair and was
told that they found out there is a new replacement for the accelerator