I have a 1997 E320 and when it first starts out in the morning it doesn't
shift well. It feels like it is stuck in second gear. After about 3 blocks
of driving everything is fine. I just purchased this car so I don't have any
prior knowledge of how its supposed to act. Any ...

I've just ordered my Viano Trend 2.2 CDI - just out of curiosity, what model
code is it? Wxxx
Best regards
Erik

I have a 97 S500 in the shop with P0715 and P0720 codes. I replaced the
connector plate in the valve body and tested the solenoids and speed
sensors. They are showing good readings from the connector with an ohmeter.
The code come back after clearing and road testing and the trans ...

I have som eproblems with ASD ( Anti spin regulation)
The control lamp is on. Is there any way i can fix that problem or do ihave
to send to repair ?? Manual is on german and my german is a little rusty
Hope some one can help

I can't find the oil drain plug on my 1991 190E 2.6. Do I have to take
the oil pan off to expose the drain plug? Thank you!

Has anyone on experienced a popping sound or clunk when
opening either of the front doors on a 1997 E-420?
When opening either door to the first "detent" position,
this sound occurs.

My wife's ML is equipped with the Bose stereo with 6 CD changer. Over the
past few weeks, the action of the changer has become increasingly erratic,
requiring several bumps of the on/off button to properly load a disc.
Now, it seems as though it's given up the ghost entirely. No ...

Obsidian Black over Gray Leather.   6 CD changer, S420
64,500 miles.  A few exterior dings.  Interior perfect.
What would be reasonable to expect for a trade in on this vehicle?
The dealers I've talked to are lowballing, I believe, as against Blue Book

Anyone have the following problem with their GPS Navigation System?
My 2001 Navigation System has extreme difficulties ejecting some music CDs.
What's the solution?  For some reason I can play and eject some CDs including
the navigation CDs, but some CDs just get stuck.  They gave ...

For Sale:  1983 300SD.  277K.  Starts right up and runs fine, steering
tight.  No issues with turbo.  Transmission shifts smoothly with no
problems.  AC converted to R134A and works fine.  New brake pads, interior
blower motor, battery, valve adjustment, heater control valve, ...

I have traced my cold start problem to the idle air control valve which
appears not to be getting the proper voltage control signal from the FI
ECU.
Unplugging the connector to the idle control valve results in no change

Anyone have any tips or tricks to getting a rusted intermediate bearing off
the shaft? This thing major rusted. Before taking a torch to it, I decided
to put a puller on it and tighten it as much as I could get it. I've been
putting penetrating oil on it for a couple of days.

    I need to know what wire connections run insice the hood. Just
found a wire disconected next to the drivers side windshield washer
nozzle. Thanks in advance...
B F Rollins II

Popular Science Honors the E320 CDI Diesel and SLK350 Convertible
   NEW YORK, Nov. 10 /PRNewswire/ -- Mercedes-Benz garnered two prestigious
"Best of What's New" awards today from Popular Science, the oldest and
best-known science and technology magazine in the U.S.  One award ...

Is this still going in the UK?  They used to send it to me every month about
four years ago but then it stopped.