| Thread | Last Post | Replies |
|
| clk 320 misfire | 15 Apr 2005 20:24 GMT | 2 |
I have a 2000 clk 320 that is showing a multiple cylinder misfire any quick fixes I should try first before I spend the usual $1000 at the stealership. I have had good luck with this car until now I cant seem to figure it out. Any thoughts would be great.
|
| C230K Sport ('96) Problems with Power loss | 15 Apr 2005 17:15 GMT | 3 |
Hi, I have a '96 C230 Sport Komp and have an intermediate fault with acceleration loss. Sometimes when pressing the pedal to the floor the car judgers and fails to accelerate, however if gradually pressing the pedal (i.e. not flooring it), then the car accelerates fine, just
|
| running too rich ? | 15 Apr 2005 07:43 GMT | 1 |
can a 300 td diesel be running too rich ? what controls the fuel / air mixture ?
|
| instument panel removal ?80 300sd? | 15 Apr 2005 02:39 GMT | 11 |
Is their a special trick, (hidden screws, clips etc) to remove the instrument panel to get at the dimmer switch. Can the switch be repaired or must it be replaced. Thanks in advance for any help. Ken
|
| Injector Pump Lube Oil | 15 Apr 2005 00:05 GMT | 7 |
Lacking a proper shop manual for my W115 240D, I do not know how to service the Injector pump. What type and how much "Oel" is needed, and how do you check the proper level?
|
| 300SD Speedometer Calibration | 14 Apr 2005 15:11 GMT | 6 |
I just got a speeding ticket in my 300SD.. 75 in a 65.... I had the cruise set at 65 or 66.. Does anyone know if it's possible to adujust the calibration of the speedomter? If so, how?
|
| wiper blades on 2004 and later MBZ | 14 Apr 2005 15:08 GMT | 5 |
I posted once in the past looking for a source for wiper blades for my 2004 E320 wagon. I commented that it cost $99 for two front, and one back blade. The back one is still "Bosch" or other after market compatible, so it was cheap, most of the cost was for the "proprietary"
|
| crashed '91 300e, question about ebay selling | 13 Apr 2005 18:52 GMT | 10 |
My son totaled my 1991 300e, and a friend told me the best thing to do with it is to sell it on ebay. It has 165,000 miles on it, lots of new parts, was in perfect condition, but now ....
|
| Amsoil for tranny? | 13 Apr 2005 18:37 GMT | 4 |
Can I use Amsoil Synthetic Universal Automatic Transmission Fluid in an '83 300D? If not, what do you folks recommend?
|
| '83 300D vacuum locking weird behavior | 13 Apr 2005 15:23 GMT | 2 |
My '83 300D turbo is behaving strangely due to some vacuum leak that I cannot pinpoint... The locking system behaves as follows: - With the A/C and heater off, engine takes a while to shutdown, and afterwards every door needs to be manually locked (seems there
|
| 86 300DSL, is center muffler important? | 13 Apr 2005 01:01 GMT | 2 |
I am quoted $800+ to replace the center muffler and front pipe on my 1986 300sdl. I asked the mechanic if he could instead just run a straight pipe through to the rear muffler (I thought the center muffler was just
|
| yet another 90 560 sel question | 12 Apr 2005 05:25 GMT | 2 |
Will they ever end? I doubt it. There is a bottle that looks similar to a plastic mini beer keg under my hood. It is located near the front grill on the left side of the vehicle (drivers side USA) It seems to be about the biggest fluid container under the hood, but it is empty ...
|
| Transmission gaskets-best place to buy parts | 12 Apr 2005 02:29 GMT | 4 |
Summer is almost here in Arkansas and Thanks to those that replied to my in /or ability to replace the transmission fluid!! Now I gotta get the filter and gasket before doing the actual fluid change.. of all the places on the net-0who is the most economical??(notice I didn't say
|
| AUtomatic Transmition Problem on Mercedes 190D year model 1986 | 12 Apr 2005 02:23 GMT | 1 |
I need any of your guys expertise on Automatic transmition, the wierd thing with my transmition is that the gears are changing very fast while i drive very slow e.g. until i get to 40 Miles the gear goes to the forth and now to get it back down i have to slow down to 15 miles to ...
|
| trarnny info | 12 Apr 2005 02:03 GMT | 4 |
I am looking for info/schematic on a valve body MB#123 270 6207 The tranny # is 123 270 3701 722 118 02 13 1195 thanks, lyndo
|