| Thread | Last Post | Replies |
|
| 124 300TE covertable to diesel? | 17 Dec 2006 01:08 GMT | 1 |
I own a 92 300D (2.5) and can get a 92 300TE at a very reasonable price. I would like to covert the wagon to diesel using the 300D as a donner. My major areas of concern are: - will transmission have to be swapped?
|
| ABS light -- cold start problem | 16 Dec 2006 22:52 GMT | 2 |
Last week had new rear brakes pads installed on 1987 300E. Since then, intermittent ABS light on dash. When ABS light is lit, car has a cold start problem that can only be overcome by leaving foot halfway down on accelerator pedal.
|
| How do I access the archives for this group? | 16 Dec 2006 20:27 GMT | 1 |
I have a 1999 E320 with some burned out heater control lamps and need to remove the radio cluster... I think. Any help out there? Thanks,
|
| 93 mercedes S350 W140 diesel-cooling temperature high | 15 Dec 2006 23:25 GMT | 2 |
I have a mercedes s 350d-W140 1993 year. When I take out the wire out of cooling temp/sensor,gage does not drop to zero.when I plug again and I drive,gage is erratic.when I top the accelarator,sometimes it drops a litle or goes higher a litle.and the
|
| 240D instant start now, thanks for the advice | 15 Dec 2006 17:45 GMT | 1 |
Great group. Replaced 4 glow plugs, used the 1/4 drill bit, made sure they were Bosch, as soon as the glow plug indicator lamp goes out she fires instantly. Thanks for all the info and help from this group. Amazes me how the 240d rides. So comfortable and smooth, not a
|
| Buying 78 300D | 15 Dec 2006 17:40 GMT | 6 |
I am looking at a 78 300D. The issue is its my first diesel and I have been told by the owner that the climate control servo needs to be replaced. They have set the servo so the heater works and purged the system of freon. Here is my issue, after talking to a couple of shops
|
| 300 SD idle speed | 15 Dec 2006 13:18 GMT | 10 |
The garage set up my idle speed too high, around 1,200 RPM. I understand it's supposed to be about 800 RPM. How may I change it without taking the car back to the shop at $90 an hour? It just runs annoyingly fast at idle.
|
| Modifying W201 190E output shaft (half axle) to fit ASD differential | 15 Dec 2006 06:21 GMT | 2 |
I'm trying to fit an ASD (automatic limited slip) differential to my W201 190E. The original output shafts or half axles will be about 32 mm too long after the swap. The ASD output shafts are hard to find so I thought I could modify the old ones by changing a shorter shaft (axle)
|
| Astonishing Secrets Of The Biodiesel Maker In The World | 15 Dec 2006 03:57 GMT | 2 |
Oil companies are pulling in record profits and the government says they can't do anything about it. Hurricanes have knocked the oil refineries down and you can feel it at the pump.
|
| E300D diesel questions. | 15 Dec 2006 01:40 GMT | 6 |
Looking at a 95 E300D W124 Mercedes. Need some input on it first... Going to test drive one in a week. 1 Why no turbo? Is this good or bad? 2 Is it a OM606?
|
| 123 Sunroof leak 300D | 14 Dec 2006 20:55 GMT | 5 |
I believe that I have a sunroof leak. I found the two front gutters. For anyone else with this problem, the front drains are in the front corners and can be seen when the sunroof is open. These gutters drain out the body near the top front door hinges. If these gutters are
|
| 1990 300 E transmission compatible with 82 300 D | 14 Dec 2006 07:49 GMT | 1 |
I am wanting to know if a '90 300 E transmission is compatible with an '82 300D. I'm selling my 300 D as a parts car and someone called who has a 90 300 E and needs a transmission.
|
| Vacuum op. accessories | 14 Dec 2006 06:25 GMT | 1 |
Hi all, glad I found you. I just bought a 1977 450SLC with 150K on her, solid but kind of a basket case. No major repairs needed but the ignition system is in need of some
|
| headlight bulbs 95 420e | 14 Dec 2006 04:06 GMT | 2 |
What are the best and brightest headlight bulbs for a 95 420e that project a far beam? Thanks for your help.
|
| 1992 300 SD door panel and center console trim removal | 13 Dec 2006 18:50 GMT | 8 |
Hi, I just got a 1992 300 SD, I need to remove the center console trim (to change some light bulb and change the radio equip), and the back door panel (the window won't go up). I can't figure out how to do it, and I'm afraid to break something.
|