Hello there everyone,
Sorry for reposting.. somehow when I'm viewing my post it was something
else.
I'm planning to recondition/rebuilding my mini's interrior. I'm wondering if

Hi there, is there anyone one out there that has just put a stage one
kit on a mini cooper (1990 RSP is the model I got) and has still got
the old parts that they could let me buy?
Or if anyone could advise on how I could get hold of such parts

I'm going to be getting my website up and running again
www.clubmanestate.co.uk a website dedicated to..... wait for it... the
clubman esate!!, I did have a bash at it last year, but however due to
family health problems moving house etc etc I didn't get anywere with it,

I'm sure it or similar has been covered previously but i can't seem to find
it- Indicators flash double time on rhs only.... just before i get round to
investigating bulb (rhs front) blows, but now neither left right or hazards
work. I'm about to go and get a bulb but don't think ...

First of all I'm new to this group so hello everyone.
Seconly, I need help...
My windscreen wipers stopped working the other day. An investigation
revealed a completely burnt out switch. Both the switch unit and the

Does anyone know where I could buy a good quality set of 12/5 miniligtht
style alloy wheels with polished rims and gold spokes with Falken 165/12s?
jono

Has anybody come across this problem before? I have a 1999 rover mini
cooper. Basically after driving for a bit putting your foot on the clutch
makes the car immediately rev and stick (at about 2000 revs), so say if you
come to a stop the car revs upto and over that, the only way to ...

Have just read Taffy's post, I have a similar problem, but my doors leak
from the top and the water runs down the inside of the window (found out
when washing my beautiful little Mini Cooper), hubby has checked to see if
there was any adjustment on the doors but couldn't find any, ...

I have an older smiths mechanical oil pressure gauge which I would to
install in my 1986 mini.
I think that the outlet is on the block underneath the outlet from the
block to the oil filter, is this correct?

I posted a question a while ago on a problem involving the steering wheel
shuddering on braking after leaving the car unused for a long time with the
handbrake on. I eventually took the rear brakes apart and realized they were
both warped, the left one just slightly, the right one ...

I'm wondering if anyone can help with whether i need to get my crank
nitrocarburised or whether i should try to find a genuine EN40B S crank.
i'm in the process of doing up the engine in my 1969 aussie cooper s.
apparently its a 'late' mk1 S block with a mk2 S engine number (i can't

Anyone know what the switches did on a Mk1 mini.  they only had one stalk
and two switches on the middle panel?  What did what?
They didn't have hazards did they?  How did the washers work?
I am trying to work out a sensible arrangement for the pickup.  I think

A familiar problem - I have a 1987 Mini with a Metro engine. The
speedo cable snapped behind the instument panel so I need to replace
it. Unfortunately the 'nut' which holds it on to the gearbox is stuck
on rock solid. I have tried putting my long skinny arms down the side

Having only discovered last week that Minis have grease nipples on the
radius arms, I thought I had better shove some grease in.
I tried to do it this morning, and the only way I could have managed it
would be to use a grease gun with some sort of special end, or take the

I've just taken this diff out of my MG Metro 1275 engine.
When I bought it I was told that the car was fitted with a Quaife LSD.
Does this look like a Quaife?
Thanks!