Folks
Where can I get a wiring harness for a mini 1275GT made up?
Thanks
Leon

I have a problem, have bought a new heater matrix but when trying to replace
the unit the inlet and outlet pipes that attach to the matrix need
replacing. Has anyone got any ideas where to buy them - I've tried all of
the usual place HELP!!!!!!!!!!!!!!!!!!!!!!!!!!!!!1

I'm looking for a rally prepared 998 or less cc mini mk1
Are these rare?
What would I have to pay for one?
Is the insurance difficult? I really want one on a classic car policy.

the horn on my 77 mini 1000 is broken, not sure y it dosen't work, can
anyone give me any advice on how to check what's worng, or possable
solutions.
cheers

Hello internet, I have a question.
Here in NZ A+ blocks are as rare as unicorn poo. I have managed to lay
my hands on this.
http://webconnect.myob.co.nz/f/p2397/67745/Olympus%20099%20(Medium).jpg

I have a mini cabrio. But the safetybelts are attached to two points.
Now I want to have safetybelts which are attached to three points
(like modern
cars) because it is much safer.

Hi all,   Just fitted my first mini windscreen....  what a pain... lol
rubber go's on fine, glass fits in rubber fine... but the filler strip!!!!
after 2 hours finally managed it with washing up liquid and a lot of blood
sweat and tears...

I've recently seen a mini Mpi airbag and the electrical connector that is
inside the steering wheel.
I noticed that the connector did not appear to have any form of
'reverse-connection' protection. It is a 2-way connector and it looked like

the gas indicator (thing that tells you how much gas you have left) is not
working, I crossed the wires and it goes to full, this indicates that the
gauge  and wireing is working, where do i go from here? Do i take the tank
off and check the float inside? any suggestions would be ...

Can anyone tell me where the inline fuse for the foglight lives ?
I've chased the wiring under the dash and then through (most) of the
engine bay but I can't seem to find it anywhere
Any help appreciated

I know its not unusual for a mini to leak a bit of oil, but its starting
to mark the driveway and i'm getting grief from the missus.
Its a 86 mayfair automatic and the oil is dripping down the drivers side
of the sump, its coming from higher up but cant see where from, nothing is

I have just got a quote for some work to be done on my car and I would like
to know if there are any mini specilist's that can do this work and if
possable, cheaper! It is an L reg Mini mayfair. The price given was a worse
case guesstimate as he could not get it over the ramp to ...

Currently i am getting a noise coming from the flywheel cover in the
area where the starter and flywheel mesh (listened through a
screwdriver pressed against the cover), the noise is quite loud,
inermittent at bewteen 2000 and 2500rpm and then increases at higher

I have a 1380cc A series with an unknow race-like cam (very cammy at
tickover and little power before 3000 rpm) and standard ratio rockers
which I'm looking to make more suitable for road use (ie. swapping the
ability to rev off the dial for low down torque available from

It's a bit late in the day to ring any parts places (ie they're all
shut) but does anyone know off the top of their head how much an offset
joint is gonna cost (in £'s please)just found a shed load of play in one
of mine