I have bought this car used with 150,000 miles on it.  Everything seemed to
be fine with the car until one day I started to hear a loud click noise
upon and after releasing the brakes.  This noise is coming from somewhere
under the car and I have brought the car to a few mechanics ...

My wife took the car to the dealer today and came back with them telling
her that the Knock sensor and the front o2 sensor code stored in the ecm.
they want to replace all three t the tune of $1100. parts and labor. does
any one know how har it is to replace the o2 sensors? please ...

My check engine light is on and i found out that it was being caused by the
O2 sensor, knock sensor and Mass air flow sensor. I haven't replaced them
yet, but i did replace the fuel filter because the car was hesistating
alot and shutting off while idling at stop signs. I've checked ...

Looking for a way to find out how to get the error codes for my 95
maxima. Ok, I bought this car about 6 mos ago, and the check engine
light was on, but the car ran great. About a month ago, the light went
out and stayed out till yesterday. Before it came back on, I had

The other day my 95 nissan maxima starting jerking and I looked down and it
was overheating.  I pulled over and that's when it started smoking.  Once I
replaced the hose that was cracked, filled up on the coolants and water I
thought everything was fine.  Now I can't go above ...

Car starts fine, idols fine, and runs fine EXCEPT when I drive over 2000
rpm's. If I accelerate slowly all is ok until I reach 60+ mph (2000 rpm).
If I accelerate quickly it shifts gears until I hit 2000 rpm's. Both cases
the car sputters and I have to decelerate. I thinking it is ...

Hi, my nissan's antenna is broken, only the antenna, I've checked the motor
and it's ok but I went to a store and they offered me a "Metra Antenna for
Aftermarket Nissan 92" (something like that) and it costs only $15.00 but
i've read that the original antenna costs about $45.

Do all the injectors 'pulse' at the same time or one at a time?  
What is the best way to 'wire in' new injector connectors? I picked up new
ones from Courtesy Nissan but the harness had only two pins for each side
of 3 injectors...  my old one has a connector with four pins for ...

Trying to figure out what to use to clean the computer like display in the
center of dash..... has smudges on from having car detailed looks greasy
wont come off with glass cleaner........ please help

No function in any door switch.
Where can I get a free wiring diagram to download?

   This concludes a long-standing effort to diagnose the tendency of my Max
to bump-steer and drift.  I began noticing the drift at 80k, currently it's
at 123k.  In the end, tightening the pinion tension adjustment corrected the
problem.  However, the cost was nauseating: $713 ...

Hi, I have a '92, all fine but the power locks don't work, i press the
button and hear a 'click' (the relay?), but the locks stay in their
position. I started to remove the first fuse (and putting it again while
pressing the switch) on the right side of the fuse box in the driver ...

i have a 99 max GLE with 85k.  just about 30 minutes ago I finished
installing a K&N cone filter to my intake system using the "ghetto" method
of using parts from inside the airbox to rig the filter onto the adaptor.
Instructions from the DIY page on the org said to seal the edges ...

I have an 04 Max SE that now has 1500 miles on it. (I traded an 01 Max GLE)
I really like the car...handles great, better gas milage than the 01, etc.
The only thing I really am finding annoying is the interior noise level. The
01 was a much quieter car.

Anyone have any problem with -(mass airflow center.)