| Thread | Last Post | Replies |
|
| Mid 90's auto trans question... | 09 Apr 2005 06:15 GMT | 5 |
...do the auto transmissions from the mid 90's have a bad rep?? tia ...
|
| Transmission drain plug location ????? | 09 Apr 2005 05:22 GMT | 2 |
Hello group. I need to change the transmission fluid in a 1992 Maxima but I can't seem to locate the drain plug. I have Chilton's manual but in the location it specifies for the drain plug is a female plug about 3/4" in diameter for which I'll need a wrench similar to a hex ...
|
| Supension probs on a 3rd Gen - NissTech? | 08 Apr 2005 19:44 GMT | 1 |
Hey again, Symptom #1: Tires are about a year old, but are worn on the inside of the tire. Had an alignment when I purchased them. This suggests either the camber is off, or they are toeing out. What suspension issues can cause
|
| Clutch Groan '99 SE | 08 Apr 2005 15:33 GMT | 10 |
Need some advice on clutch groan. When I am stuck in stop and go traffic in my '99SE 5Speed the clutch will make a groaning noise after several repeated start and stop cycles. It's been doing this for at least three years now and doesn't seem to be causing any problems. Any idea ...
|
| Popping noise while turning | 08 Apr 2005 05:51 GMT | 3 |
'91 Maxima, 178,500 miles. When I turn a corner, my front end makes a slight "popping" noise. It doesn't happen when I actually turn the wheel, but when I'm moving through a turn. I'm thinking this is the ball joints going bad, but I'm not sure.
|
| washer fluid | 07 Apr 2005 19:02 GMT | 4 |
Has any one come up with a good additive to add to the blue washer fluid to help it clean better?
 Signature b
|
| Replacing a Manual seat with an Electric - Help!! | 07 Apr 2005 18:59 GMT | 1 |
I bought a "new" electric driver's seat from a '90 GXE from a junkyard to replace the old, worn out, and now broken manual one on my '91 SE. Under the manual seat is one electrical connector, but under the electric there are 2. Does anyone know what is involved in getting that ...
|
| '96 Maxima acceleration/idling/gasing problems | 07 Apr 2005 14:48 GMT | 6 |
I have a 96 Maxima that started idling rough - idle would drop to 200 RPM and bounce up to 700 RPMs back and forth and on acceleration from start would give and go and kind of kick into acceleration. The car began to stall out at stops after braking, and then recently the car would ...
|
| Cylinder Misfires | 07 Apr 2005 03:27 GMT | 6 |
I have a 99 Maxima that had a code indicating that there was a cylinder misfire on #6. As a quick fix, I replaced all the plugs since they have 55K miles on them. The car seems to running rougher than before.
|
| Can't get out of park | 05 Apr 2005 16:17 GMT | 2 |
1996 maxima Can't get the car out of park? Any ideas?
|
| Question about P to D | 05 Apr 2005 01:26 GMT | 3 |
When I shift my (2002) Maxima into drive from park, first thing in the morning, it delays about 4-6 seconds before the car responds. You can feel it shift but before idle drive kicks in, it is stagnant. Does anyone else have this problem?
|
| 2000-2003 Maximas are unreliable? | 03 Apr 2005 11:05 GMT | 5 |
I keep reading subtle things that the 2000-2003 Maximas are not reliable. Can anybody provide more info on this? I know about the ignition coil problem. Are there other serious problems?
|
| 93 Maxima Oxygen Sensor Code 33...Again??? | 02 Apr 2005 15:47 GMT | 4 |
Any idea what would cause an oxygen sensor error (code 33) on a 93 max GXE, just one year after the same sensor was replaced? The current error code and symptoms are identical to what it was doing before I replaced it last year...It starts OK when you turn the key, but when ...
|
| Poor gear shifting in my 92 maxima | 01 Apr 2005 05:21 GMT | 2 |
My 92 maxima is shifting funny. The engine rev is not in synch with the car movement. When I shift to drive and put my foot down on the gas pedal, the engine rev rises but not proportionately with the car speed i.e. lots of rev and very slow movement.
|
| Maxima 1989 Elctronic dashboard display | 01 Apr 2005 03:30 GMT | 1 |
I have a Maxima 1989 GXE with 220,000 Kms. Lately the electronic display dashboard has started to fail, specially on very cold days. I suspect a lose connection, but I am not really sure. Any suggestions?. Gabe
|