Yesterday my brake and battery lights came on in my 2001 maxima. Then this
morning, my wipers were not working at full strength. When pulling into
the neighborhood, the entire dashboard when completely dead (tach, speedo,
oil, gas, radio, etc.). What is going on?

I just replaced the struts on this maxima, everything went fine according to
thr instructions.but.....when I started to drive it the car bucks and
shimmies badly, only under power. If I let off ont he pedal it smothes out
and seems to be aligned fine either when driving or brakng.

OK, I've had Check Engine Light code P0153 a few times and once
P0133.  P0133 is front O2 bank 1, 153 is bank 2.  If I clear the CEL
it may not come back on for weeks - but it pings a lot especially when
cold.  Nissan service guy says it could also be the Mass Airflow

I tried to pass the Washington state emissions test and failed.  After going
to the dealer to get the check engine light to go away and be able to pass
the test, I got soaked for $200 for a gas cap and a hole in a canister.
Well, that's all fixed. Now my check engine light is ...

i made a post in the past about this and did what you have suggested. I
changed transmisson oil cleaned out the pan and changed the filter. but
the transmisson still skips. there were no metal particals in my oil when
i drained so the trans is no broken. what would u suggest i do ...

Hi. I'm sure this isn't a fault, I just can't figure out what the hell
it is. It's really bugging me.
I have a 2001 Maxima, auto. And when I turn the engine off, there are 4
or 5 sounds in a row that sound like some sort of pump. At first I

I was backing up and when I was shifting to reverse I heard a klunk
sound. Now, the gear shift is in neutral and I can't shift to any gear
at all. When I let go the clutch the car moves forward. I got it towed
to a tranny place and after taking it apart they found out that it was

I replaced my crank shaft pulley and belts on my 95 maxima
now the whol car shakes in the lower RPM range, maby timeing problems,
what coud lit be?  It has to be rel;ated to this pulley instalation
thnak you for any help!

I have a question for someone who has the repair manual CD for a 2001
Maxima.  My factory radio (non-Bose)recently died from my 2000 Maxima, and
the dealer told me the radio was identical from a 2001.  I bought one from
Ebay, and I find that they are NOT identical.  The 2000 has ...

Hi all. I have having some problems with my car and I have searched
countless threads here and learned very much. Great little area.
Here is my problem.
I have a 1994 Maxima, Automatic. About one month ago it began to have

  My 95 Maxima  started making a noise yesterday. The water pump and belt
were replaced about 6 months ago. I'm sure the noise is coming from the belt
that drives the alternator and air cond. compressor. Also after running a few
minutes I see and smell smoke but can't locate the ...

I am trying to diagnose a problem with my headlights.  I'm in Canada so I
have Daytime Running Lights (DRL) on my Max.  The problem is that the DRLs
light up okay (they use a lower light setting on the high beam bulb), but
then when I turn on the headlights and the high beams the ...

On a cold Qu?bec morning, my sister started her Maxima 2000. The
engine ran roughly for a few minutes, and then, ran smoothly from that
point on.  The ?Service Engine Soon? light came on.
She drove to a dealership for a diagnostic.  They pulled codes P1320

1993 Maxima,  any tips on changing the rear struts, did the fronts and there
like any other car; quite easy.  The rear look like a pain in the butt.
Never done them,  any help, steps or advise would be great.
Thanks Brian

A 96 Maxima recently came into my care. The Check Engine Light was on
when I got it. Codes (0304 Knock Sensor) and (0302 EGR Hi/Low Flow)
were stored in the ECU. The car had 130,000 miles on it. No "blow-by"
from crank case, no smoking and not consuming oil. It had an