| Thread | Last Post | Replies |
|
| 1998 Nissan Maxima MAP Sensor P0105 | 09 Mar 2006 14:27 GMT | 2 |
I have a 1998 Nissan Maxima that is reading P0105 on the diagnostic test performed by Auto Zone. It also reads that the Knock Sensor is out. Could one sensor caus the other to read a malfunction. The Auto Zone dealer also stated that I needed 2 MAP Sensors, however, I've been
|
| HID bulbs for 02' Maxima | 08 Mar 2006 16:02 GMT | 1 |
Is there a difference between all the D2R 35w bulbs? The stock bulb that came with my Maxima is a D2R 35w 85126. I know what the first two numbers are and I can find many of them out there that are D2R 35w bulbs i just have no idea if the trailing number means anything
|
| Installing gauges | 08 Mar 2006 01:07 GMT | 4 |
Hi friends, I have a Maxima 1999 and I'd like to install some gauges on my car - There are so many gauges available in the market - like www.autometer.com or even at www.custommaxima.com . Some of the gauges that seem interesting are the
|
| Rear Wheel Hub Bearing? | 06 Mar 2006 02:30 GMT | 1 |
I have diagnosed a failed rear wheel hub bearing by hearing a noise that increase with frequency as the car speeds up (97 Maxima SE, 118K Miles). The tire was swapped to insure it wasn't associated with that. I am finding that the only place to obtain another bearing is at the ...
|
| 1997 Maxima hard starting! | 06 Mar 2006 02:30 GMT | 3 |
When engine is cold it starts then turn off after 2 seconds, repeatedly. Only way is if gas paddle is pressed down about one inch and start then release gas paddle after about three seconds which is now normal mode of first start. After that no problem all day long unless not ...
|
| 1991 Maxima VG30E Removal. | 05 Mar 2006 12:16 GMT | 3 |
I recently bought a used engine and plan to do a swap myself in the near future. I read my chilton's front to cover and was wondering if there was anyone out there who had experience with this car. If there is a website that has pictures and a write up that would be great. I
|
| help! 90 maxima will crank, kinda start, then die....fuel pump? | 05 Mar 2006 07:33 GMT | 5 |
i just got a tune up (sans set of wires) car was running a bit rough, as if it were missing. fuel injectors all tested fine. one day after tune up,it would die immediately after starting, took a few times to get it going. i put in a new set of wires. didn't help: it will crank and ...
|
| 1995 Nissan Maxima GXE is it worth saving? | 04 Mar 2006 18:52 GMT | 4 |
Not mechanically inclined - I have a bunch of problems with my 95 Maxima GXE and wondering if its worth paying to repair. Automatic Transmisison needs rebuild, 2 Axles need replacement, rear struts need replacement, brakes need replacement, wiper motor needs replacement. Rattle ...
|
| trany skips | 03 Mar 2006 13:07 GMT | 1 |
i have on more problem. When i drive the transmission skips. Like when i get out of first gear the rpms still go but the gear had changed already then the rmps drop. Its like a 1 second delay. I noticed it in 1,2,3 of my gears and it does it randomly.(I HAVE AUTO TRANS). Thank you ...
|
| abs system brake failure | 02 Mar 2006 09:20 GMT | 1 |
i recently wrecked my 2002 maxima the body is now fixed the other day i was driving my car and when i stepped on the brakes the car made a noise and the brake pedal just got hard but the car did not stop it just kept going i had to use the emergency brake to stop -- if you slam ...
|
| 95 Maxima: Replacing Lights in Switches | 02 Mar 2006 03:14 GMT | 1 |
Could anyone advise me on how I can replace lights in the switches on my 1995 Maxima SE? It's becoming harder to find them while driving at night. Do I need special tools? Can I somehow take off the front templates to replace them or do I have to remove the entire dashboard or ...
|
| clutch problem -- 2005 maxima | 01 Mar 2006 20:50 GMT | 3 |
Help! I've got a 2005 Maxima with about 12K miles. A couple months ago this fine piece of automotive engineering stranded me: the clutch pedal stuck to the floor and became nonfunctional. I had it towed into the local dealer. The next morning when the tried
|
| V6 Maxima engine not starting | 01 Mar 2006 19:02 GMT | 3 |
I have a 94 maxima manual (V6) , the engine will not fire when cranking from the starter. When I gave it a push and jumped the clutch, the engine fired and ran normally. When I switched off, same thing happened, crank the starter and engine not firing, gave the vehicle a push and ...
|
| Need parts, 97 Maxima | 01 Mar 2006 14:57 GMT | 4 |
I need a drivers side tail light assy., quarterpanel mount, and a rear view mirror on the passenger side. IF it is possible the rear view mirror needs to be sage mist green, parts are for a 97 maxima.....any and all help greatly appreciated, I have high performance parts to trade ...
|
| clear CEL on '94 maxima? | 01 Mar 2006 14:56 GMT | 2 |
Are there some connectors or a key trick, etc. to clear the CEL? tia Carl
|