Home | Contact Us | FAQ | Search & Site Map | Link to Us
Sign In | Join | Other 45 Sites in Network
HomeAnnouncements
Discussion Groups
By Brand
BMWChevroletDodgeFordGMHondaLexusMercedes-BenzNissanPeugeotToyotaVolkswagenOther Brands
By Topic
4x4 CarsRVsDrivingMaintenance & RepairCar AudioCollectible Cars
Country Specific
Australian ForumsUK Forums
ArticlesAuto InsuranceBuyingCars & TechnologyMaintenanceMiscellaneousSafety
DMV Resources
Related Topics
MotorcyclesBoatsMore Topics ...

Car Forum / Nissan / Nissan Maxima / September 2007

Tip: Looking for answers? Try searching our database.

ThreadLast Post  Replies
96 maxima not starting29 Sep 2007 02:35 GMT1
i have a 96 Nissan Maxima, which is currently stuck and not starting.
the problem started two weeks back when it was starting in a dragging
manner. 2 days back i jumped started the car to no success. I
recharged the battery and even tried with another battery but the
Remote Controller 1995 Maxima SE24 Sep 2007 22:06 GMT1
I am looking for an extra remote controller ( mine is working fine)
for a 1995 Maxima SE. None of the local wreckers have any. I am north
of Toronto in Barrie, Ontario, Canada. Thanks.
Andy's MAX 200022 Sep 2007 01:17 GMT2
Would anyone know about this problem?  My 2000 Nissan Maxima with 80,300
miles.  Recently I had the front disc brakes replaced.  Three weeks later,
the ABS light came on.  I went under the car to see/inspect and didn't see
anything unusual.  Two weeks after that, I inspected ...
95 Maxima ..strut mounts or bearings????19 Sep 2007 03:59 GMT4
My front struts are moving up on top.  When I raise the car in the front
and grab the tire I can move the the whole thing around and can see that
the large center nut on the top is moving around.  The nut is tight but
looks like the diameter that holds the strut is larger allowing ...
How to detect worn constant-velocity joints?19 Sep 2007 02:58 GMT3
I was told that constant-velocity joints start making noise when the
car tunrs; when the wear increases they make noise even when the car
runs straight.
Could you give tips that allow to detect which one of these is worn?
2002 SE low pressure valve/air consitioning question14 Sep 2007 04:56 GMT3
Hello - I have a 2002 SE and the air conditioning has been out for the
last week.  I put off buying any 134a until tonight.  I am assuming
the low pressure port is on the line leading from the passenger side
dashboard to the front of the engine to the compressor.  The valve cap
2008 Intelligent key question12 Sep 2007 04:44 GMT7
Hi, I have a 2008 Maxima and according to the dealer and the manual I
should be able to stand by the trunk with the fob in my hand or pocket
and press the button on the trunk lid to open it. The problem is that it
will not open this way, not even a click. It will open using the ...
Maxima 1995: OBD II P1355 code (Nissan DTC 47: Crankshaft Position Sensor Reference)11 Sep 2007 13:40 GMT2
It starts easily at any temperature, even on a very cold Qu?bec
winter.
It runs smoothly, almost always...
Very seldom, it hiccups for a second or two while I drive at regular
car problems09 Sep 2007 04:27 GMT1
hello;
      i have a 1991 nissan maxima the right headlight low
beam don't work on that side only. the highbeam works but not the low
beam. i put the bulb on the other side and it works
Oil on spark plugs of 2001 Maxima with 90000 miles06 Sep 2007 21:52 GMT3
I was changing the spark plugs on my 2001 Maxima and I noticed that
there was a noticeable amount of oil on the spark plugs. 2 of them
were quite a bit worse than the rest, but they all had oil on them. I
did some searching on this group and found this post:
87-MAXIMA - GAS cap HISS- no longer05 Sep 2007 07:00 GMT1
When the gas cap is removed to add fuel [87 MAXIMA], I no longer hear a
HISS sound. Will this change in fuel tank or gas cap  cause my car to
fail SMOG test and recertification?
Dave_S
97 Maxima GLE Power Antenna02 Sep 2007 02:32 GMT1
I'm attempting to replace the power antenna mast only, the motor is fine. A
while back, 3 of the 4 telescopic sections complete with the nylon geared
cable ejected and simply came right out leaving the final 4th piece in the
sleeve. The nylon cable seems to be fine, no breaks, so I ...
 
Sign In
Join
My Latest Posts
My Monitored Threads
My Blog
My Photo Gallery
My Profile
My Homepage

Start New Thread



©2008 Advenet LLC   Privacy Policy - Terms of Use
This website includes both content owned or controlled by Advenet as well as content owned or controlled by third parties.