was kostet normal folgende Handwerkerleistung?
Antriebswelle links und rechts aus- und eingebaut,
Manschetten au?en erneuert
R?der gewuchtet und gewechselt

 Does anybody know how to get the round plastic things that go through the
seatbelt (to hold the buckle where you can reach it) out?
I'm missing the one from my driver's seatbelt, so I thought I'd try to get
one from one of the back seats.  This was easier said than done though.  ...

Do any of you other Nissan owners have annoyingly grabby brakes?  This
complaint has been lodged against the G35 a million times, and I've heard
one mention of it on the 2000+ Sentra.  My Sentra (95 200SX SE-R) can really
tire out a leg after repeated exposure to stop-and-go traffic ...

i have a 1985 nissan 300zx and wondering if i could port and polish the
engine?  how much would that cost and how much HP,and torque would i
gain???????   thanks

I have a 98 Pathfinder and I'm having a problem controlling the air flow
inside the car.  No matter what setting I chose most of the air comes out of
the upper vent.  The fan is working fine, my problem is that I cannot get
too much air to come through the lower vent or defroster ...

Anyone ever heard of a driveshaft literally snapping on an SR20De (the
case of the e is very important) engined car?
I was pulling away yesterday in my 1994 Nissan Primera 2.0 Automatic,
when there was a clunk like someone hit me from behind and I realised I

i have a 98 frontier with a 2.4 and i want to upgrade to a vg30 has anyone
swapped? is it a lot of work? are there any websites that have this info

As long as I've been driving (30 years) I've used the max tire
pressure value on the sidewall as the guide to proper inflation.  I
endeavor to keep the tires at that pressure.  For the last couple
years I've been getting my Frontier's oil changed at the local Jiffy

It has 37360 miles on it I ran carfax on it and everything is fine. Has
all service records on it. The dealer is asking 23,890 on it. im going
to see if they will go lower. Has everything except DVD.
Any comments wouldbe appreciated.

I have a 1986 Land Rover County 110 which I have had from new.  It had a
2.5 Nat Asp engine which stopped working twice in the first 60,000
miles. The man who was then the Technical Editor of the Land Rover
Owners Magazine replaced the engine with a Nissan FD35 3.5 ltr Turbo

THE BRAKE LIGHT IN MY XTERRA COMES ON IN THE AM.  IT GOES OFF AFTER A
WHILE....SHOULD I TOP OFF THE BRAKE FLUID?  THE PADS SEEM TO BE FINE

Hi, I have a problem with manual transmission,
I have a 87 Sentra manual transaxle, having 111K miles on it.
Recently, I start having problem shifting 1st gear from neutral, it is not
always and usually happenes after wating for the signal, and I can move the

It looks like the windshield was changed on my 2000 I30 (it doesn't
say Nissan on it). On the outside bottom of the glass where the wiper
arms are attached, there is a plastic cover with blow holes. This
cover has a rubber seal which attaches to the windshield. It doesn't

Hey all,
The windsheild washers on my '89 240SX don't work.  I'm guessing that it's
the pump - what else should I check other than fuses?  Any relays?  Where
are the windsheild pumps located, and how do I test them?

Just replaced the front brakes on a 1995 Nissan Quest van.  I retopped off
the brake master cylinder, but for some reason the "brake" check light is
still on on the dash.  It was getting dark and we did not have time to bleed
the brakes, but I drove the vehicle and the brake pedal ...