| Thread | Last Post | Replies |
|
| shifting when engine is cold | 14 Nov 2004 00:57 GMT | 11 |
I thought I had this fixed when I replaced the temp sensor. Still does the same thing but at a lower outdoor temp. Has become a problem since the temp in Ma is dropping. My 90 Stanza refuses to go into 3rd gear (auto trans) unless the
|
| how much - pathfinder 2003 LE | 13 Nov 2004 03:47 GMT | 2 |
i was wondering can someone please tell me how much would a used but mint pathfinder 2003 LE go for? i tryed to find some sites via google for the
|
| nissan sentra 2000: annoying air conditioning feature | 12 Nov 2004 19:22 GMT | 3 |
I recently bought a used 2000 sentra and am fairly pleased with it. There is a feature that this car has that's really annoying that I'd like to disable if possible
When I select venting for the front window on the HVAC selector dial I
|
| 90 PU Headlight problem | 12 Nov 2004 19:18 GMT | 5 |
I have one working headlight, no daytime running lights and no highbeams. Its not the switch, the fuse and I don't have a relay near the fender in the engine compartment like another post suggested. I have traced the problem to the fuse block where the power goes in to the
|
| Pathfinder makes whistling noise | 11 Nov 2004 23:06 GMT | 19 |
I have a ?99 Nissan Pathfinder. Couple of weeks ago it started making whistling noises when in idle. I replaced my drive belts and narrowed it down to my A/C belt. When I start the car without the A/C belt the noise is gone. When I put the belt on and tighten the idler pulley ...
|
| Nissan trims | 10 Nov 2004 20:41 GMT | 2 |
Hope someone will answer this question. How do the Nissan trim (SE/XE/GXE/GLE) ordered? What do they mean GXE? Is GXE is the top of the line or GLE? Iam doing my homework so that I can retire my Ford Escort LX. My first
|
| Ash Tray for '04 Frontier? | 10 Nov 2004 19:40 GMT | 4 |
Anyone know if there is an ash tray for the Frontier ('04)? It looks like they made a space for it below the stereo, next to the 12VDC socket. All I've found so far is a portable ash tray that fits in the cupholder. Thanks.
|
| 2001 Frontier 4cyl Timing | 10 Nov 2004 14:00 GMT | 3 |
Anyone know offhand whether the 4 cylinder engine in the 2001 Frontier used a timing belt or a chain? If belt, when is the recommended replacement? Thanks,
|
| Heater/AC Fan Resistor | 10 Nov 2004 02:44 GMT | 1 |
The heater fan speed control only works in the high speed position (i.e., 4). This appears to be a common problem with all Nissan models and is likely due to a open circuit in a resistor pack. Where is the resistor pack located on a '99 Altima and how is it removed?
|
| Question about computerized wheel alignment | 09 Nov 2004 16:52 GMT | 7 |
I took my sentra '94 for the CV boot change and I got computerized wheel alignment with the CV boot job... After the job was done I got the printout as follows: Initial Specification Final
|
| 92 Pathfinder Oil Leak | 09 Nov 2004 04:54 GMT | 13 |
My 92 Pathfinder has developed an oil leak at 93k miles. If you were to look underneath, the drops are falling from the back side of the oil pan (not a loose oil drain nut or filter). The oil appears to be coming from the starter side, then drips down the bell housing/onto the ...
|
| 2004 Nissan Quest Shift Knob Removal. | 09 Nov 2004 00:22 GMT | 2 |
Does anyone know how to remove the shift knob from one of the new Nissan Quests? I thought it would from beneath the shift buttom, but that does not seem to do the trick. Does anyone have any suggestions? Dave...
|
| Anyone got whistling wind noise in 2nd gen Altima? | 07 Nov 2004 21:01 GMT | 3 |
I've got a slight whistling noise somewhere around both front doors on my 99 Altima when driving around 80 km/h. Has anyone else noticed this and been able to pinpoint the cause? I've taped over the seal around the window, and between the door and the
|
| Gear Shift Knob on 2004 Nissan Quest | 07 Nov 2004 17:25 GMT | 2 |
Does anyone know how to remove the gear shift knob on the 2004 Nissan Quest?
|
| Question about tranny replacement for 2k2 Altima | 07 Nov 2004 14:49 GMT | 1 |
For the base 2.5 model, I am considering buying a used one with a manual transmission and might have to get an auto tranny installed. Anyone have any idea as to how much that would cost? TY.
|