Home | Contact Us | FAQ | Search & Site Map | Link to Us
Sign In | Join | Other 45 Sites in Network
HomeAnnouncements
Discussion Groups
By Brand
BMWChevroletDodgeFordGMHondaLexusMercedes-BenzNissanPeugeotToyotaVolkswagenOther Brands
By Topic
4x4 CarsRVsDrivingMaintenance & RepairCar AudioCollectible Cars
Country Specific
Australian ForumsUK Forums
ArticlesAuto InsuranceBuyingCars & TechnologyMaintenanceMiscellaneousSafety
DMV Resources
Related Topics
MotorcyclesBoatsMore Topics ...

Car Forum / Nissan / Nissan Cars / April 2005

Tip: Looking for answers? Try searching our database.

ThreadLast Post  Replies
panel light dimmer resistence for 94 Altima12 Apr 2005 17:20 GMT4
Anyone know what the resistance of the dimmer pot should be? How many
watts? I need to replace it or maybe just put in a fixed resistor at
about half brightness setting
Thanks
acceleration problem12 Apr 2005 16:44 GMT3
my 94 pathfinder stumbles on acceleration, runs fine until i push harder on
the accelerator then stumbles a bit, i have the correct new ngk plugs , new
quality wires, cap and rotor...could this be an O2 sensor going bad or
something else? any suggestions? the check engine light has ...
2001 Nissan Quest GLE - Bad Gas Mileage?12 Apr 2005 14:22 GMT8
We purchased a used Nissan Quest a couple of months ago, and we really
enjoy it except for the gas mileage. We live in a hot climate, so we
usually have the AC turned on low (at 72 degrees). Most of the driving
we do is city driving. I know these factors lower the MPG, but we
FS: SR20DE engine & 15" rim12 Apr 2005 06:25 GMT2
SR20DE engine for sale with out the trany about 110km.
set of 15" rim (racing hart) with tire, rally style.
best offer!
email me for pics.
93 sentra classic, electrical problem... help!!!!!!12 Apr 2005 06:23 GMT1
It started with the battery light, very dimly lit, and whenever i
turned on the heating it would turn on even more, i thought it was the
battery connectors, so I changed them. It didn't work, well it didn't
light up as much as it did before but still would turn on.
Should new shocks raise height?12 Apr 2005 02:18 GMT6
I've got a 2001 Infiniti I30t that had worn out shocks.  Today I had
the local tire store chain install new shocks/struts (in the I30t, the
front are struts and the back are shocks).  I had all 4 replaced with
what I was told would be identical shocks/struts as original (could be
Nissan Hybrid Cars:  Any plans?11 Apr 2005 23:51 GMT2
I am curious to know if Nissan has any plans to release a hybrid car
(gas/electric).
With the high cost of gas these days...you gotta ask...especially for city
driving.
Is the 2005 Nissan Quest an acquired taste?11 Apr 2005 16:27 GMT3
While our 2000 Odyssey is in the shop, we're living with a free rental
car provided by the dealer.  It's a 2005 Nissan Quest with only 3000
miles on it.  Ordinarily, I'd be savoring my chance to drive such a new
and powerful vehicle over our Odyssey that's been around the block ...
3rd gen Maxima replacement struts10 Apr 2005 23:45 GMT2
I believe it's time to replace my 94 GXE's front struts after 114k miles.
(non-sonar)
What is a good brand/type to use if not the Nissan factory struts?
I don't want a "performance" ride (i.e. stiff or rough), I just want like
Smoke!10 Apr 2005 22:44 GMT10
   I've got a 2001 Maxima with 17000 miles on it. Needless to say it
doesn't get driven very much. Yesterday I took it out for the first time in
a while and drove about 30 minutes on the interstate  to a friends house for
Easter. Drove back and put the car in the garage. Started ...
96 Sentra....   How to remove cv joint without ball bearings falling out??10 Apr 2005 20:28 GMT1
I recently discovered that the outer cv joint boot on my 96 Sentra GXE
is torn.  In order to replace the boot, I have to remove the outer cv
joint.   Here is my question.....  Frequently in the past when I tried
to remove the cv joint, the ball bearings would come out of their
'92 240SX clutch fluid leaked out09 Apr 2005 22:39 GMT7
Any help is appreciated, Thanks in advance,
The fluid leaked out of the clutch master cylinder inside the car.
So I replaced the clutch master cylinder and the slave cylinder.
I am having a very hard time getting any pedal.
95 200sx ser no rev past 5000rpm09 Apr 2005 22:23 GMT4
i've got a 95 200sx se-r that won't rev on a fresh cold start it will but
it warms up it chugs at 3000rpm then fully warmed it cuts out at 5000rpm
fuel preshure is good (45psi) i swaped distrbuters the tune up (plugs
wires cap rotor fuel filter ect) is fresh oh ngk plugs help me out ...
96 Sentra: Need help on replacing cv joint boot on drive axle09 Apr 2005 15:00 GMT6
My 96 Sentra GXE has a torn CV joint boot on the drivers side.  It is
the outer boot and it appears to have occurred recently.  I want to
replace the boot, but it entails the somewhat difficult job of getting
the outer cv joint off.   I have had bad luck in getting the cv joint
85 pickup 08 Apr 2005 18:17 GMT9
I have a 85 se v6 hardbody 4x4, when you turn the key to the on position,
the injectors start spraying fuel into the manifold before you even try to
start it. what controls this?  is  the computer broken? thanks
Pages: 1 2 3 4 5 6 7 8 March, 2005
 
Sign In
Join
My Latest Posts
My Monitored Threads
My Blog
My Photo Gallery
My Profile
My Homepage

Start New Thread



©2008 Advenet LLC   Privacy Policy - Terms of Use
This website includes both content owned or controlled by Advenet as well as content owned or controlled by third parties.