| Thread | Last Post | Replies |
|
| Advice need for scratches inside of car door | 20 Nov 2005 01:06 GMT | 3 |
My young daughter has scratched her name into the inside part of the door of my Sentra. It's not deep, but it's noticable. Is there any way/product that can get rid of it? Thanks for your help
|
| nissan titan recall | 19 Nov 2005 15:17 GMT | 2 |
is there or will there be a recall to replace the brake rotors for the nissan titan? i been reading about a bad design that causes it to warp and heat up quicker than it suppose to. whats up with this? anyone know?
|
| Help Me With My Spark Plug Wiring! | 19 Nov 2005 01:10 GMT | 1 |
I gave my 93 Nissan Sentra E, 1.6L, a tune-up yesterday and now it wont run, it would run the night i did it but it would spit and sputter badly. I think I got the plug wires out of order, which order do they go in - and where do they plug into the distributor at (as in which
|
| 97 Sentra, Error Code P0400 | 18 Nov 2005 13:19 GMT | 2 |
CEL is on, Autozone reads error code P0400, EGR Flow problem. What is the fix for this and where do I start? Thank You. 109500 miles. High Octane Gas, regular oil changes.
|
| FS: 2004 TITAN LE | 17 Nov 2005 20:46 GMT | 1 |
Anyone interested in buying a 2004 Titan...please post here or email me at parsonmr@earthlink.net Mike
|
| 95 Sentra main seal oil drip | 17 Nov 2005 07:31 GMT | 3 |
I'm thinking it isn't a problem with the seal proper, because it stops dripping when the engine has been off for a while. This suggests that there is pressure in the crankcase when it's running. Any agreement? If so, what component(s) will prevent the pressure from venting? My old
|
| Infiniti I-30 strange knocking problem | 15 Nov 2005 06:53 GMT | 2 |
hello group, i own a 1999 Infiniti I-30 car, and lately its been acting weird. whenever the speed is above 35mph, and ESPECIALLY when i take my foot off the gas pedal - i hear this knocking sound from the engine
|
| nissian z timing | 15 Nov 2005 00:12 GMT | 1 |
i have a 1988 nissian pickup with a 4 cylinder z24 motor i put a new head gasket kit in now i'm trying to set the timing i went by the book (CLYMER)but it doesn't seem to be right ithas the setting for a regular 4 but knot the z motor i'm trying to find where should the rotor be ...
|
| New Nissan Almera | 14 Nov 2005 19:03 GMT | 2 |
This Question refers to the Nissan Almera in Europe. Since the latest Nissan Almera is almost six years old, it would be interesting to know what the successor - the new Almera will look like. Or will it be a European version of the Nissan Versa that was presented
|
| 2000 sentra shifter button sticking | 14 Nov 2005 15:25 GMT | 1 |
This has been a pain.I've tried lubricating and have not been able to free it up.Can anyone help?
|
| Nissan 240 SX fails to continue to run | 14 Nov 2005 12:52 GMT | 3 |
1989 Nissan 240SX with the fuel pump, fuel filter, and fuel pressure regulator replaced. Upon starting, the car will idle for about 1 minute 30 seconds and you can run the engine up to about 2000 RPM above this the engine starts to die. Toward the end of this time the engine will ...
|
| 99 Nissan Altima | 13 Nov 2005 21:08 GMT | 1 |
I failed emissions for EVAP Control System Pressure Sensor and Purge sensor valve. How I fix these errors? 99 Nissan altimaSE. Thanks
|
| Micra crankshaft position sensor fault | 13 Nov 2005 20:56 GMT | 1 |
Micra -year old seems to keep getting fault with crankshaft position sensor. Anyone with similar-problem- how was it fixed?
|
| parking lights on 2002 frontier | 12 Nov 2005 23:39 GMT | 1 |
i'm a little embarassed about this question but the drivers side front parking light is burnt out on my frontier and i can not figure out how to get access to that light to change it. anybody that has done this before please help. I have practically taken apart the entire front ...
|
| terrible fuel economy | 12 Nov 2005 16:56 GMT | 3 |
Oh my god. Im getting five miles a litre out of my car, 1994, Nissan Primera, SR20De engine, automatic. What should I be looking at? The only noticable real problem is a total lack of get up and go (but only at times), apparently the camshaft and rockers are worn and could
|