| Thread | Last Post | Replies |
|
| '91 Nissan 240SX Radiator & Thermostat Questions | 08 May 2006 08:03 GMT | 4 |
I'm replacing the radiator and thermostat in my '91 Nissan 240SX and have a couple questions: For the thermostat, Nissan says to just use liquid gasket (silicone/RTV). However, several auto parts places sell a flat gasket
|
| Do 1998 Pathfinder SE's (4x4) come with a factory installed hitch as standard? | 08 May 2006 05:05 GMT | 4 |
I spoke to a UHaul representative regarding the rental of an auto trailer. The UHaul rep indicated that all 1998 Pathfinders (SE 4x4) should be preconfigured with hitches and ready for ball attachment. The only thing I see under the rear bumper is the full size spare tire. I
|
| Pain At The Pump: Government Gas Secrets | 08 May 2006 04:19 GMT | 4 |
http://www.wesh.com/painatthepump/9141621/detail.html
|
| 2000 Nissan Altima | 08 May 2006 02:16 GMT | 3 |
I have bought a 2000 Nissan Altima few weeks back. I noticed that my cooling fan inside the hood seems to be running even after I switch off the engine. It always take extra 1-2 minutes for it to stop. Is there any problem with the cooling of the engine? I will appreciate any help.
|
| Trouble starting my 99 Sentra | 07 May 2006 23:39 GMT | 8 |
After 2 days of sitting I went to my car and tried to start it. It fired immediatly but stayed alive for about 2 seconds then died. I started it again and it just wasn't kicking in. Finally I started it again, only this time flooring the gas pedal until she kicked in, then once ...
|
| How to remove rear seat in 97 Quest | 07 May 2006 23:39 GMT | 1 |
Can anyone tell me how to remove the rear bench sear (last row) in an 97 Quest? I need to install new speakers in the back, and it appears the only way to do this
|
| Any advice on stanza L16 engine replacement options?? | 07 May 2006 23:35 GMT | 1 |
Hey all, I have an 82 stanza GL, with an L16S-A engine/ 3spd auto trans. Not too much trouble with the engine, bit of oil coming out around the front of the head but other than that quite stable. I am however pondering
|
| '83 pulsar problems | 07 May 2006 04:25 GMT | 4 |
I have an 83 pulsar, it used to idele great, but sporadically would bog down horribly when the accelerator pedal was pressed down. I found a tear in one of the rubber things before the throttle body and taped it up, now the car wont idle but it runs ok when the rpm's are up. any ...
|
| door lock relay | 06 May 2006 01:15 GMT | 2 |
Does anyone know where the door lock relay is located on a 1993 nissan pathfinder se?
|
| Nissan Altima the "engine service soon" light turns on??? | 06 May 2006 00:09 GMT | 2 |
Dear Members: in my nissan altima 1997, the light "break" and " engine service soon" turn on when I start the car? can you please tell me what they mean and what shoud I do>?
|
| Pathfinder | 05 May 2006 16:18 GMT | 4 |
I am looking at a newer Pathfinder 2002, well new to me, how are they on gas consumption?
|
| Nissan PU Coolant Temp ? | 05 May 2006 12:00 GMT | 4 |
Hi, I recently had a "lazy" t/stat replaced on my 2.4 lit. '97 Nissan PU. Although the motor warms up much faster (and gets warmer) than before, the temp needle reads 1/8" - 3/16" shy of the centerline (on the C side). This is on an 90 deg. day. Is this correct? Do these ...
|
| 91 240sx whistling upon startup | 04 May 2006 22:21 GMT | 4 |
I have a 91 nissan 240sx, automatic, from time to time it make a loud whistling type sound when I start it and then when I start to drive this will continue for about 10 seconds, some times get louder initially then it stops and doesn't occur again at all while driving
|
| once more, nissan service is stumped | 03 May 2006 01:21 GMT | 1 |
had frontier 2006 in the shop for parts of 2 days, due to the "clang" metallic clang sound is heard after car intially started, hot or warm and gears change from 1st to 2nd, sound occurs very loud if engine has been off for 8 hours, less if engine off just a few minutes
|
| FREE 1886 Nissan 4x4 with blown engine- last call! | 02 May 2006 21:02 GMT | 2 |
I'm about to give this to a parts yard to get it out of here. I'm outside of Eugene Oregon. The head gasket went and my wife kept driving it and I'm pretty certain the engine is FUBAR, but the rest of the truck was working fine at the time. This is the "ST" version of the ...
|