i need to replace a broken coil in the front and was wondering how hard
is it to change, thanks

I lose about 20 psi in 30 seconds. Is this oK? If I pinch fuel line
between fuel filter and gauge, I dont lose the pressure so I know the
check valve or canister or gas tank is leaking. Not sure if this
abnormal.

Recently, my 2004 Quest has been accumulating water in the rear cargo
area so much so that there is up to 1/2 in deep of water at a time.  I
live in Seattle and it has been quite rainy, but it does not always
happen when it rains. I suspect the water is coming in from the bottom

Hi. I have 2 Primeras, both SR20De engines (I think .... 1997 2.0i SE)
one of which is failing to start. It is not operating the fuel pump
when the engine cranks, i.e it runs the fuel pump for 2 seconds as the
ignition comes on and is then supposed to run it again as the starter

I have a 1993 subaru wrx, has had, water pump, gasket (not Head
gasket), thermostat, radiator, and heater unit where the radiator cap
is, replaced with new and some good used parts, but the car still over
heats, i have noticed that the heater dosent work when on hot, and full

Heater doesn't blow hot air a idle, ether have to rev up the engine or
drive to get the heater to blow hot ait.   The Engine Temp guage is
reading normal after warm up, (needle is sitting at mid point) engine
isn't overheating.  the rear heater is experiencing the same problem.

The clutch slave cylinder went out on my 97 Pathfinder about 6,000 mile
ago and when I took it to the shop, I asked if I should replace the
clutch master cylinder at the same time. (that is usually the
recommendation as far as I know) The tech claimed there wasn't any need

Yesterday, I went to a chain tire store to get my tires rotated and balanced
because I received a coupon from them in the mail. While waiting I went to
the nearby mall for a short while. On my way back to the tire store, I saw
my 95 Nisson pickup on the rack with the hood up. ...

I have a curiosity question:
Under the front of the Murano on the driver's side, is a sort of split
rectangular funnel type of device or structure. It must be only about 3
inches high, about 8 inches wide, and about 6 inches deep. Can anyone

The seats in my 01 Sentra have never been comfortable but after
breaking my hip I can’t hardly drive it or get in and out!  Does
anyone know of another seat with lumbar support that will fit and not
sit me too high up either (I have claustrophobia too).  Thank you for