| Thread | Last Post | Replies |
|
| 2002 Bravada cam sensor location | 12 Oct 2005 04:33 GMT | 1 |
Can anyone tell me the exact location of the cam sensor on the 4200 Vortec in the 2002 Bravada? I had a fault code set indicating the cam sensor, but it hasn't set the code again since I took it to the dealership for a diagnosis.
|
| 82 olds delta 88 - starts when it wants to start | 12 Oct 2005 01:28 GMT | 5 |
FOR THREE WEEKS MY WELL MAINTAINED CAR WILL ONLY START WHEN IT WANTS TO. THE MECHANIC HAS BEEN ALL OVER THE CAR LOOKING FOR PROBLEMS AND IS JUST STUMPED BY THE CARS PROBLEM. WEATHER HAS NO BEARING ON THE PROBLEM. WHEN IT DOES START, IT RUNS FINE. HELP.
|
| tire size | 10 Oct 2005 00:15 GMT | 1 |
I just got an olds 88 1997 it has 205/70/15 on it I have new tires that i want to put on it but they are 215/70/15 will they fit
|
| windshield wipers | 09 Oct 2005 03:55 GMT | 1 |
i have an 98 intrique recently my wipers stop working anyone know where’s the motor located [wiper motor] :lol:
 Signature Posted using the http://www.autoforumz.com interface, at author's request
|
| 98 Bravada hvac issue. | 07 Oct 2005 17:49 GMT | 3 |
My girlfriend has a 98 Bravada, and lately she is getting very hot air coming out of the floor air ducts, no matter what she does. It doesn't matter if the fan is on/off, whether the temp is set to cold/hot, and whether or not the system is set on auto. Just a while
|
| 91 CUTLASS SUPREME POOR IDLE AND STALLING | 07 Oct 2005 06:31 GMT | 1 |
I HAVE A 91 CUTLASS, 3.1 V6 I HAVE REPLACED THE SPARK PLUGS, WIRES, IDLE AIR CONTROL, MAF SENSOR, ECM, FUEL PUMP TWICE, FUEL FILTER, HAVE RUN INJECTION CLEANER IN IT, DRY GAS AND THE PROBLEM IS WHEN IT WARMS UP IT BEGINS TO IDLE ROUGHLY AND SOMETIMES STALLS THIS CAR ONLY HAS 30000 ...
|
| Side Window Seals | 06 Oct 2005 02:31 GMT | 2 |
Would anyone know where I could get some new side window seals for a 1984 Olds Omega Brougham 4 door? The originals are discontinued. Thanks. Rod
|
| Delta 88 codes 26, 65 | 06 Oct 2005 00:46 GMT | 1 |
1988 Olds Delta 88 3.8 C engine I have a steady check engine light. Codes are 26 and 65. My Haynes manual says 26 is quad driver module. There is no code 65 listed.
|
| HELP! 1988 Olds engine trouble | 05 Oct 2005 16:11 GMT | 4 |
started with service engine light then immediately followed by battery light then car stalled. Before it broke down, it would jerk going up the road and would stop if i gave it more gas. I changed the injectors, coil pack, new module,computer, ect. I cant figure out what is wrong ...
|
| 1990 olds 88 doors won't unlock | 05 Oct 2005 15:49 GMT | 2 |
i have a 1990 olds 88 with power locks i am afraid to lock doors i cannot get rear doors to unlock ether power or manualy i wonder if there is a safty system that is not letting the doors unlock any help would be appericated
|
| 94 olds achieva coolant system pressures up | 05 Oct 2005 00:31 GMT | 2 |
I have been experiencing repeatitive problems with the coolant system pressuring up in my 94 achieva. The system has caused me to change the gaskets in the intake twice, I have changed the rad cap and flushed the coolant system. I am not overfilling the system, as it is quite ...
|
| 97 Olds achieva - Heater Core replacement | 04 Oct 2005 05:46 GMT | 1 |
Gold old Plastic engineering! one of the plastic input nipples on my heater core broke so now with winter coming up I need to replace it. On a scale of 1 to 10 what kind of a job is it? The Haynes manual makes it look as simple as removing dash panel, stereo, and ac/heater controls ...
|
| CATALYTIC CONVERTER | 03 Oct 2005 23:58 GMT | 1 |
I drive a 1991 oldsmobile cutlass ciera and a couple of months ago I took my car to Midas and told them that I had a foul odor coming from my car and they said it was my catalytic converter. But within two weeks I had to get a new extension pipe put on and i disregarded the foul ...
|
| 1991 Oldsmobile Ninety Eight | 03 Oct 2005 11:15 GMT | 4 |
Silly Question: Where is the starter located for a 1991 Oldsmobile Ninety Eight. If it is relatively easy to do, I going to try to change it myself!
|
| replacing starter on 1987 olds regency 98 | 03 Oct 2005 10:58 GMT | 1 |
Does anyone know if you have to remove the exhaust manifold in order to remove and replace the starter
|