I'm about to buy a Peugeot Partner D1.9. Any experiences pro or con?

I think the nut has come off one of the roof bar mountings on my 99 406
estate. Last time I used my roof box there was a lot of creaking from the
area around the rear of the left side bar. Over the last month or so there
is a rattle coming from the same area when I drive around ...

The rear washer on my 1999 106 Zest 3 is the "click switch once to start the
wiper, click and hold another notch to activate pump" type.
Driving home tonight I tried to wash the rear window, but when I pressed the
switch to the 2nd position to activate the pump, the relay used to ...

Months back I posted a enquiry about  the cold start problem with my 406 and
the general consensus was a faulty sensor.  Well a fresh, to me dealer, took
said motor allowed the car to cool , then plugged in the computer and no
problems. They had it over night tried in the next ...

Does anyone have any idea what is causing this problem?  The LH, RH and High brake lights come on as soon as the ignition switch is turned on.  They stay on during driving and dont change on depression of the brake pedal.  I have checked fuses - they seem OK.  All the other ...

Hi... I have a H plate 205 1.9 GTi wich has recently failed its MOT due to a
complete lack of rear bump stops.  I have purchased a new set from my local
dealership, but i cannot get my head round how to insert the stops into the
holding rings once they are bolted onto the car... has ...

you can see my project at work on http://www.outwar.com/page.php?x=1679701

I upgraded my lights with a hella xenon package and it is working
perfectly........check it out at http://www.outwar.com/page.php?x=1679701

Hello does anyone have a picture of what the IAT sensor on the air intake
looks like.  I have  a part to fit to this but I can not find out which part
it is ?  I own a peugeot 206 which is 2 years old.  I want to fit a small
device which allegly increases the power to engine by 15%, ...

Hi all, a long time since I've been on here - I thought I know all
there was to know about my car but I've been stumped again :)
Its an old 205 with the TU1 engine. Where the speedo cable is held
into the area around the driveshafts with a rubber pin I have struck a

Hi, I have just replaced the clutch on my 205 (1989 XR, TU3) as I lost all
gears when the engine was running. Thats all fixed, no problem...
However, since I got the car back from the garage I have lost all power to
the radio, have no reversing lights and have no dash board ...

the passenger and rear window defrosts but the drivers mirror doesen't
defrost,ne 1 had this or knows how to get to the wires at the mirror?

1996 306 XLD ELECTRICS
hi all
can anyone tell me why i have no light when i open any door, the roof light
switch has to be moved from the open doors to the light on position and that

Hi, I seem to get very intermittent heat coming into the car even when the heater is set to hot and fan is on full and engine is hot too.  All the instruments (fan, flaps etc) seem to be functioning but no heat getting to me.  It's very cold! Any ideas as to what's broke or what ...

Remember that I asked how to fix a rusty spot right in the middle of the
flat area behind the second window in the left side and where it could have
come from?
On the 306s, there are inner fender (correct word? The area around the