My HDI 90 (actually in a Xsara) doesn't want to rev over 4000, and the fuel
consumption is rather worse than I had expected. It pulles really well at
lower revs, far better than the 1.9 TD in my old 405.
It was serviced, according to the manual, 3000 miles ago by a main agent, so

Hi my 405 is the 1.6 multipoint ign, my Q is can you get an induction kit
for it as i have been to the k+n web site and it's not listed... thanks
nick

just bought a 1998 4dr v6, driven it for 250miles and now the coolant
level light comes on from cold,flickers, then goes out after 1-2 mins.
Naturally I'd like to visually check the coolant level but can't seem to
see the expansion tank (seems to be tucked deep into the engine

Hi, I have a 206 XSi -01 bought used, and I was wondering about rear
speakers for it. There are none there today - does anyone know if there
is wiring there? Is it easy to install speakers afterwards?

I've got a 1998 406 glx auto with a warning light showing for the ABS. I've
sent it to a garage and they have checked the logs (whatever that means) and
they say there is nothing showing up. They say that the sensors are all
showing optimum readings apart from one which is just a ...

I have a a Peugeot 405 deisel N Reg. Driving home  a red "STOP" Light came
up on dash, I have no owners manual & don't know what this means (it
flickered on/off intermitanly then ended) !!!
tonyb

Bear with me. This needs a bit of explaining.
On a 406, there is a large nut right at the end of the drive shaft which
is visible if you remove the wheel trim. There is a hole drilled through
the drive shaft, but the nut itself is not castellated. Instead, there

I have a 306 ST 2.0 Sedan (i.e. a 306 XSI with a boot!), and it has
suddenley stopped working with a problem with the immobilizer programming
(or so the road side recovery man said).
The conundrum I have is whether to

Was wondering if there are any Peugeot techs who might know what
transmission code 130 is on a 206 automatic 1.4 2001?
My scanner reads undocumented code. Even when cleared, the code returns
immediately.

I have a 97 2.1 TD and seem to have an electric fan fault - I just cant get
them to come on. (This is the GLX with climate control air con).
This model has 2 fans. Should they both come on together and vary speed
according to temp or should one come on supplemented by the other at ...

I have a PUG 406 1.9TD 1998. Today I noticed for the 1st time a clicking
noise behind the dashboard/glovebox are on the passenger side. Its a strange
one this, a series of 8 or so audible 'clicks' then a short (second or so
long) faint mechanical whiring noise. This is repeated over ...

I have  just bought a new 307 Envy. Sometimes, when I turn on the ignition,
I hear 3 beeps. Can anyone tell me whay they signify?
Thanks.

I need to replace the front discs on my '94 306 XTDT. The ATE caliper is
help in place by two guide pins. Can anyone tell me what size socket I
need to remove these as they are surrounded by a dust shroud and I can't
see how to get them out!

On turning the ignition key to start there is often just a click. A few
goes will cause the starter to turn over and it isn't really a problem but
is this a sign of a starter problem or ignition switch or wiring/bad earth?
Any easy cures?

I have a small problem with my 406.... The rear brakes are totally shot.
I have removed the caliper/disk/hub and am trying to seperate the back-plate
from the handbrake cable, but it won't let go...
I havn't got a manual, can anybody tell me if these parts are seperate,