| Thread | Last Post | Replies |
|
| Peugeot 406 '96 Immobiliser Locked! | 30 Mar 2005 08:57 GMT | 2 |
I have a 1996 Peugeot 406 1,9tdi , but unfortunately I got the immobiliser locked because of 3 times wrong code. After that I waited 30 minutes for the beep to stop and tried again. It won't take the code. In the manual it is said that when the green and the red lights light at the ...
|
| 205 1.9 GTI Engine problem | 30 Mar 2005 08:46 GMT | 5 |
I have a pug 205 1.9 GTI. My problem is as follows; The throttle seems to be either on or off, by this I mean it is very difficult to drive the car smoothly; if I try and apply a small amount of throttle the car will jump foward. If I try and hold the car at a steady
|
| 306 1.9 D clutch adjustment | 29 Mar 2005 22:23 GMT | 2 |
I have recently begun to service my car instead of paying the garage lots of money to do a few farily simple tasks. However I a having problems working out how to adjust the clutch travel. Does anyone know how?
|
| HDI fuel leak | 29 Mar 2005 22:19 GMT | 2 |
My 306 1999 HDI has developed a fuel leak. There is a srong smell of diesel in the engine compartment, and when you remove the engine cover fuel has collected in the shallow wells and there is also a slow drip though the engine onto the floor. Has anyone else expereinced this ...
|
| 206 clutch problem | 29 Mar 2005 20:27 GMT | 2 |
Hope someone can help me. I have a 22 month old 206 Xsi with just over 16000 miles, the majority of which has been A road/ motorway driving. The clutch biting point has always been high, noticable after driving
|
| 307 Hdi 90 2001/51 'Pinking' | 29 Mar 2005 17:49 GMT | 3 |
Our 2001/51 307 Hdi 90 has been suffering a bit recently. When the engine is started in the morning, with the air-con off, the engine at idle does not run smoothly, but is quite erratic and lumpy. On 2 recent occasions having driven to the bottom of the road and dipped the clutch at
|
| Peugeot Partner 1.9 D alarm system | 29 Mar 2005 15:58 GMT | 2 |
My Peugeot Patner 1,9 D can?t start today, alarm light are flashing. How can I repair the alarm system? I have permanent beeping/ yellow light flashing, and can?t not start the car.
|
| 106 car stereo wiring colours | 29 Mar 2005 13:53 GMT | 2 |
My girlfriend just bought her first car - a Peugeot 106, and I've promised to put in the stereo.. But there are only a bunch of wires sticking out, in colours that don't match those on the stereo. Can someone tell me which wires go where and what to watch out for?
|
| elctrical problems | 29 Mar 2005 10:21 GMT | 12 |
car: Peugeot 205 1.6 GTI (F reg) The fog lamp does not work One brake light does not work One dipped headlight does not work
|
| Puggy 406 2.1TD engine niggle | 28 Mar 2005 21:31 GMT | 2 |
I have a '98 Peugeot 406 with a 2.1TD engine, which seems to work fine, but there is a slight niggle with it. When I first start the car in the morning, a few seconds after it starts I can hear and feel the engine kind of stalling but it never does. The idling speed drops from ...
|
| 405 1.8 GLi Petrol - 'Engine Diagnosis' light | 28 Mar 2005 21:22 GMT | 7 |
the yellow light shaped like an engine with a 'K' in it has started flickering on and off. The handbook says 'injection or ignition'. Firstly, what sensor(s) pick up the problem?
|
| Aerial Mast on 206 | 28 Mar 2005 17:52 GMT | 1 |
How easy is it to remove the light pod, it doesn't come off easy and I don't won't to force it without knowing what I'm doing?!?! Any ideas??? Cheers
|
| 98 306 water leak drivers door | 28 Mar 2005 16:57 GMT | 1 |
hi hope you can help i noticed when i got into my 98 306 today when it was raining that there was water coming in i open the drivers door and the water is coming in on top of the seal then running into the car.
|
| Mileage and reliability for a 1.8 406 | 28 Mar 2005 16:16 GMT | 4 |
My 1998 1.8 petrol 406 has just passed 100,000 miles and has been serviced as per the peugeot servicing recommendations, with a new MAP sensor about 6 months ago. How many more miles will it last? I see loads of 406s as taxis so they must
|
| Oil everywhere........!!!!!!!!pug 106 | 28 Mar 2005 01:08 GMT | 2 |
Hi guys id appreciate it if anyone could help...... I changed my air filter from the standard air box to a pipercoss filter about a year ago now.......noproblems wat so ever...... wanting to up grade i bought a BMC CDA air box......only differnce
|