Got a problem with my 306 1.9 XLTD
For some reason my alarm has decided to go off on one...the central locking
seems to work ok as does the deadlocking but when I try and start the car
the alarm is triggered...I wait for the glow plugs to heat up and

I'm trying to install a tachometer into my '98, 1360cc Peugeot 205.
Model: 20AKD2
Engine Model: TU3FM
I cannot find the wiring to connect the tach too. (There is no tach in the

Hi    406 2lt Turbo Exec
Has anyone come across any problems with the Headlight washer's
Mine died recently, Haynes shows the relays etc but it's a real pain to
move the wheel arch covers.

This is very annoying.
Does anyone else driving a 307 get other drivers flashing main beam at them
when driving with dipped lights.
Vehicle empty other that driver, and lights adjustment set to level.

My daughters car keeps revving onits own  a garage has quoted ?110 for a
new valve ?, does anyone know which valve as the garage didnt't sayand is
it a job that can be done by me .
Chhers Steve

When should I change my  cambelt on a 1400cc 1998 306
Cheers

Can anyone suggest why our '98 Phase 2 cabrio sometimes refuses to stay
locked?
It  has the two button remote and when you press lock button the doors
lock - then immediately unlock.

I changed the timing belt (including water pump and tensioner) on my 406
HDI about 7000 KM ago. The timing belt has now started to make a whining
noise when I start the engine when it's cold. After letting the engine run
for about 5 minutes, the noise changes I character, and ...

Hi could do with some advise, just purchased a 306 turbo diesel, could
someone tell me how often the cam belt needs to be replaced, the car has
105k on the clock, was told when i purchased it that it was change about 6
months ago when the vechicle had its last service but looking ...

I've got a 1997 Pug 306 1.4 Style and have noticed a small amount of Oil
appearing on the underside of the engine.
It can't be leaking a lot as it doesn't appear to be affecting the
engines oil level, when checking by dipstick. It's just passed the

i have just open my door from the drivers door inside and it clicked and
the handle stuck out i pushed it back in and it seemed fine but when i
open it now the handle feels very slack .
it locks ok and closesfine but thedoor handle from the inside is very easy

Can anyone confirm if the Pug 306 1.4 1998/S engine has valve clearances
which can be adjusted, and what the syptoms of incorrect clearances
would be?
The engine does appear to idle a little lumpily at times (nothing

Hey guys
Can someone pleeeeease help.
1990 Peugeot 205Gti, Auto. Fuel Injected .1.9L, (Japanese Import(I
Think). (The most frustrating 205gti in the World)

Ok, heres one for your all. I have a 1993 Peugeot 106. Mum was driving
along the other day and both headlights went out at the same time and I was
left with side lights and full beam only. I posted a thread in march about
this problem, and someone said it was the dim-dip resistor. ...

Ive just had a new clutch put in my car cos the old one was knacked
and now the speedo dont work.  This I can put down to a sender unit
not responding and so I can change that!
However, I notice now that my car vibrates a lot more than it did,