I have had a couple of people come up to me and ask me do diesels have a
choke.if so what revs should the engine read before it is warm and comes
off choke.
this is new to me .thanks from chris Addlestone

My 1998 306 TD LX was never a good starter. It has always taken 3 or 4
   s on a good day to get it going, even after fitting new heating
plugs. I last changed them about 40,000 miles ago  - it's now got
120,000 on the clock. So when the car almost refused to start one very

can someone help please
my main beams arent working anymore, both of them!
the side lights come on, and when i flick the full beams, they come on but
my main dipped beams arent coming on

The handbook suggests that this is standard on all models, and to do it you
simply move the left/right selector switch to the appropriate position when
in reverse, move the mirror and then the car remebers that position and
returns to it when in reverse (with the left right selector ...

Can anyone tell me why the heater on my 2001 406 hdi 90 heats up so quickly,
i'm not complaining, i'm just amazed and think there must be a heater heater
? - iyswim
Regards Jeff

Anybody know a good place to get tyres???and not too pricey.

have a 1997 306 XL with a deadlocked rear nearside door. All the other
doors respond normally to lock/deadlock from the remote but this door will
not open. The manual lock operating button will go up and down as the remote
buttons are pressed but the door will not open either from ...

I have a '95 405 TD 127,000 miles and am worried the head gasket may go
as it's a common problem.
What causes them to blow?
Would replacing it with a new one (not a service requirement) allow

Can anybody else with a 110HDI engine in a 307 or 406 tell me what their
normal engine temperature is (according to the dash). I'm sure mine is to
low, it's been reading no more than 70 since I got the car in July...
shouldn't the needle be sat in the middle of the temp guage? i.e. ...

just wondering if anyone reading has any experience of these chips?. I have
been quoted around £190.00 for a 307 2.0hdi (90) to take it to around 125bhp

My 1993 205 diesel has what I suspect is a collapsed rear wheel bearing
(grinding noise, loads of play in wheel, wheel nuts all tight). I've not
had a chance to take it to bits to check yet but I have had a look at
the Haynes Book Of Lies and it suggests that the ...

will 306 15inch wheels go on a 106, any1 help. thanks>

Will shortly be embarking on my first cambelt change.
405 1.9D non-tubo, non-A/C, non PAS (yipee!)
Question..
Having read the Haynes manual, I still can`t see why you have to remove the

Can anybody tell me which is the best way to stop a door sticking to the
rubbers in this cold weather,thanks from chris

Is there a pollen filter on the 307? The handbook suggests that the pollen
filter should be changed, but makes no mention of where it might be as far
as I can see.
Brian.