I have fitted a tow bar on my 106.
I am wondering where the best place to drill the hole to bring the cable for
the electrics into the boot area?
Thanks

Can anyone advise why my 96, 306 xldt starts great from cold, runs
great, had new filters,plugs & battery, but when engine is hot,
struggles to re-start.

I suspect something is very wrong with my 306's service indicator. it
does not come on with the first turn of the ignition. But if I turn
the lights on with the ignition off the spanner lights up but with the
trip and odometer mileage.

All,
After returning from a holiday yesterday I noticed that the front suspension
on my 406 3.0 V6 looked low on the OSF. (the top of the wheel is about 40mm
into the arch) Having peeked under/behind the wheel I noticed that there are

Gents
I was in Halfords at the weekend and found that they have a ratchet spanner
about 1Ft long specially for replacing Peugeot glow plugs. Should be great
to get at those two aquard ones behind the diesel pump on 406's. Unless you

I have a 406 GLX 2.1 turbo diesel. - "R" reg.
Does anyone know where the temperature sensor is?   This is the sensor for
the outside air temperature as displayed on the multifunction console - the
one that displays the radio information.

My driver side speaker has stopped working. I've tested another speaker
on the connection coming into door and it works. It must be the wiring
in the door to the speaker (or the connector). The speaker worked on
and off for a little while but now it is all together dead.

The clutch on my 99 coupe has always been crap, i find it heavy and it
creaks badly, just put a new cluch cable on it, made no difference, it
seems to creak (Loud enough for passers by to look at traffic lights)
round the pivot arm that the clutch cable pulls under the bonnet,

I have a 2004, 307 1.6, when I let my car idle or when travelling at low
speed I get a terrible rattle/knocking noise coming from the front.
Any ideas what could be causing it?
Tx

Car is a 306 Turbo diesel P reg.
Yesterday I noticed that the battery warning light was off when I
turned the ignition, and its stayed off ever since except for the
occasional stuttering dim glow.

Have a 106 which currently only one head lamp is working correctly,the
other is dim, changed bulb and no change. i have seen in other posts
that the dim/dip resistor needs replacing, is this a common fault, if
so where is the dim dip resistor located and is it easy to change,

Eh, mebbe I am being extremely dense here, but I can't work out how to
replace the wiper blades on my car. Can't get the wiper arms far enough off
the screen, can anyone tell me how to do this please?
Ainslie

I have a 3dr 306 Turbo Diesel hatchback which serves me well.
However, if I lift up the front seats to let someone into the back, when I
put them back down, they don't always catch.  This means that the person in
the rear gets a seat plus the weight of the person in front flying ...

Having installed a Phone kit in my 406 "03" the Satnav does not operate, on
screen display says "CD ROM Unreadable" or "CD Missing". on disconecting
the phone kit the display still shows the same errors Only when i
disconnect the battery for resetting does the satnav return to ...

sean
i would suggest the gunk is your anti freeze/coolent. if it was brown it would sugges
your cylinder head was going
Try a a rad weld solution to start as its the cheapest option.£3-£6 go for the dry option