A lightning strike very near my 307 seems to have damaged the
multifunction display (clock, radio, computer). Does anyone know whether
the (much cheaper) 206 display will operate in the 307? Perhaps the
Citroen Xsara or C4 displays will also do? Anyway, the Peugeot part

Recently my 205 1.8 turbo diesel was exhibiting the following problems:
1. Juddering clutch in first gear
2. A loud vibrating noise coming (I thought) from the gearbox area when
I slowed down in gear. The noise would disappear when I put my foot on

Hey . . . I came across this great site for auto parts and accessories.  The prices are low,
which grabbed my attention.  The site is located at:  www.carparts-accessories.com
Posted Via Usenet.com Premium Usenet Newsgroup Services

has anyone experienced a load bang during load changes,
e.g. releasing the clutch quickly, turns or changing forward to reverse?
It's a 2000 406 Coupe 6V.
TIA

Recently I took my 307 2.0lt in for 90K service and was told by the PUG
mechanic that the transmission required 1 litre of transmission fluid.
He said it happens every now and then.  It seems to have softened the
gear changes but recently started doing it again.  Can anyone tell me

My Peugeot 306 HDI from 2001 is not coveret 100% in the 306 Haynes manuel 93-

In the Wiring diagrams they refere to ECU pin 19 but on by car thats K2 on
the brown connector (The VSS signal).

I have recently bought a 1999 406 Estate (Diesel Executive 110
version).  There is one irritating issue with it.  It pulls in to the
left.  So far I've had a 4 wheel alignment done on it and the vendor
*says* he has changed the wheels about without any change whatever.

My 307, has this issue with the transmission/gearbox. The vehicle will
run normally if i am accelerating or keeping the car in constant speed.
If I decelerate, the transmission changes down (and this is normal).
After this the transmission cannot change up anymore. If I restart the

Hope you can help.
Here is the problem:
My A/C would not work when the car was holding still at an traffic light, I
found that the engine fan motor was 120% dead, changed it with a new unit and

Hi, I have a 607 where the interia ventelation fan has stopped working. It
hasn't worked for a few months, but strangely today the fan blew air at me
for ten seconds or so, but then went off again. I hought it may have been a
fuse untill this happened today. Does any body have ...

Anyone knows the nominal (new) an the minimum allowed thickness of the rear
brake discs on a 307 2.0??
Thanks in advance
NielsC

Help, i have a 2.0 dturbo hdi and i am getting steering judder at about 70mph
onwards, i had new tyres which have been balanced the garage has checked it
out and still the judder is present and is now driving me up the wall is this
a common fault with the 307.

I made the acquirement a few months ago of a 406
It sometimes arrives that the motor doesn't want to start without obvious
reason
Agents Peugeot don't find anything

I have unmounted my Peugeot 406's (2.0 HDI from 2002) Cabin Fan Control
Module, a little back box with 2 green connectors and a heat sink.
I think the transistor on the module is defect, and would like to mount a new
one, but I can't find a place where they sell this transistor.

Thanks for your thoughts. I should have mentioned that the wear pattern is
constant across both front tyres and tyre pressures checked, every two
weeks. Cannot imagine tracking as beiing a problem. I do,however, recollect
many occasions when the front tyres "scrabble" to gain ...