OK is it me but after 30 mins and a couple of grazed knuckles i replaced
the offside headlamp bulb in my 206. I thought i was being daft in how
tricky it was to do and i dont even have fat fingers!
Unless i was just not getting the 'technique' then i would not want to

I wonder if anyone can give me a bit of advice here. I want to change
the fuel filter on my 1997 106 Independence. The configuration of the
couplings to the filter is different to my Haynes book which shows
metal clips. I have tried to lever off the couplings but they don't

Got the Peugeot 106 XND out of the garage (it's been SORNED for the last 6
months) and replaced the battery, checked the oil and the water. The water
was very low so replaced that with a 1:1 mix of coolant to water.
On starting up the car, the temperature warning light stays on and ...

This is my third Peugeot - I had a 504 and a 505 before my current
406. I kept each of them for a long, long time.
My 406 SV had its cam belt replaced recently - it has 127k kms up and
is going fine.

Is it difficult to change the fan belt on my car or does mean a garage job?
many thanks
tony evans

Due being forced into having a company car my 406 S Estate must go. It is a
late 2003 110 bhp with 126,000 motorway miles with 13 main dealer service
stamps in the book, many of which are intermediate oil changes.The car has
mostly been used for commuting between Lancashire and ...

I have a leaky water pump on my 405 TD but need to drive 150 miles,
mainly motorway. Never faced this before. Questions:
1. Can the leak get worse very fast?
2. Will the temperature guage - reliable up til now - get unreliable if

I have a 407 SW HDI 136 (4K miles) that every so often makes a loud
"diesel" knock from the engine even under light throttle - between 1500
& 2000 revs.  At same time the engine will hesitate on light throttle -
only happens for a few minutes.  Problem will then disappear for

I have a aftermarket fitted tow bar and the trafficator  repeaters light for
the trailer has been fitted next to my right knee where you cannot see it.
Is there a light on the dash board that can easily be connected for this
purpose and where can I pick up the wiring in the loom ...

test test

Hi chaps,
Have a 2001 406 HDi and was wondering if anyone has replaced any of
the bulbs in the instrument panel.
I spoke to the local peugeot garage and they say that there is only

Need to change the fan belt on my 306, any advice please is it a straight
forward job or is for the garage?
Many Thanks
Tony Evs

Hi chaps,
Have a 2001 406 HDi and was wondering if anyone has replaced any of the bulbs in the instrument panel.
I spoke to the local peugeot garage and they say that there is only one bulb in the whole panel whereas the only dim portion is the fuel guage and a small part of the ...

my brake lights on my 306 meridian have stopped working . any advice on how
to fix them? bulbs ok fuses ok ????

My exhaust broke today on my 206.  Its the front section (to the front
of the car), which includes the catalytic converter.
Got two quotes (fitted) - £400 from National Tyres and £275 from Kwik
Fit.  Do these sound sensible, obviously the Kwik Fit is much cheaper,