Well some one out there on this group might know the reply to this?
on a ribbed drive belt why does the ribbs wear off or break off?after
one year on being on the car,i said it could be too tight.well i leave
upto the group for the replys,

My left hand headlight leveller doesn't work. Any ideas what might be wrong?
Andrew

Daughters 1.4 306 power steering is whining a bit on full lock (both ends).
I also noted that if you turn the steering wheel quickly whist stationary,
the engine revs increase briefly then settle down again. Is this normal or
is it possibly the pump on its way out and putting ...

Just bought a 2003 406 2.0 hdi (90). The glow plug warning light doesnt come
on as the hand book says. Spoke to another owner today and he says hes
doesnt either, they dont come on on this model. Is this a problem or
'normal'.

I'm thinking of trading-in my Pug for a Focus, but I don't know if I am
getting shafted or not over the trade-in offered.
The car is a 2002 406 Rapier 1966 HDI 90BHP model, 67570 miles, FSH,
good condition, mot due in Jan '08, and I am being offered £2000 trade-in.

Peugeot 306, 1998 1.4l petrol, manual windows.  Today I wound (manually)
our driver's side window down fine, wound it back up again and it closed
but something didn't seem quite right.  Tried to wind back down again
and found winder felt a bit jammed, didn't move very well and ...

well i got part numbers for my crankshaft pulley but they cant tell me
which one is fitted unless i remove the pulley and take it in to them.
(((anybody know which part number is the right one,0515g3-0515k9 or has
any one fitted one of these numbers to there car.))

Just had the engine light come on accompanied by a beep and the "Unblock
Diesel Filter" message. The error comes and goes (goes more than comes) but
I am not sure what it means. Having read various posts on various forums I
am led to believe it could a) just be a filtr ...

Recently bought a Peugeot 106 which had a non standard radio cassette
in it. On inspection I discovered that instead of using an ISO
connector, the person who installed the device simply cut the wires
and used tape to connect them up. All well and good, but this lead me

Gents
I am having starting problems first thing in the morning after the car has
not been used for several days.
I have to crank it for some time and turn it off and on to get it to

How do you get this out? I have got the outer CV away from the swivel
axle and then undone the 2 bolts that you have to turn through 90
degrees, BUT there appears to be a shouder on the inner part of the
drive shaft which stops it moving outwards.  When I pull on the outer

Well has anybody done a steering boots on a 405 diesel with power
steering? i have been told that you can get rubber boots which will fit
over the shaft(power steering ram)is this right?i have never replaced
those things on a pug with power steering.

2002 406 Rapier, 90 bhp.
The indicator stalk is misbehaving - when I straighten up after a right
turn the stalk drops right down and starts indicating left, instead of
cancelling properly - this has caused a couple of near misses with

2003 406: How do you get the gear knob off, just it just pull off or unscrew
or other?
Thanks
Richard

My 806 has developed a very nasty little quirk of cutting off fuel to the
engine whilst on the move! So far I've been lucky in that I was driving
slowly and on quiet roads when it 'decided' to cut out and there was no
following traffic but for how much longer??