Our Peugeot 306 1.4l petrol, 1998 version has just started (as in today)
 idling quite lumpy once started - such that you feel it's going to
stall (or at least, can imagine that it might).
It's just passed 120,000, so is getting longer in the tooth.  Had it's

I have a 1998 406 Hdi estate and my offside soil spring has just
snapped, luckily when I was pulling into a driveway at about 5 mph!
RAC guy said that suggested that he could see no other damage to the
tire or brake lines.  I am 'reasonably' technically minded and have

This has happened a number of times over the last couple of weeks on my 2004
307 sw. Today I drove 10 miles and when I stopped I noticed that the cooling
fan was going at full speed when I have turned the ignition off. I thought
it would stop after a few moments but it only ...

Does anyone know how this works? I looked around the web - Wiki has a
good section - but could not find how the Peugeot system works.
Presumably there is some sort of sensor in each tyre?

Looking for a caliper repair kit with rubber boot slide protectors.
Any help as to where I can obtain them would be appreciated.
Looked in all the usual places GSF,Pugspares Ebay etc.
Many thanks,

Can anyone recommend a suitable fault code reader for a Peugeot 306 1.4l
petrol (Equinox badge), originally purchased in 1998, August I think.
It's a UK model and is the new style.
It has the 'standard' OBD connector behind the internal fuse box (in the

Had 2 tyres replaced today and when they took the old ones off they
found a small crack on the inside rim of one of them. These are 17"
TSW alloys which aren't made any more so no hope of getting a
replacement. New tyre seals fine but they told me I could get the

Can anyone give me some rough prices I should expect for some work -
I've tried my local Peugeot garage, but not quite sure of the figures as
the person didn't seem too clued in (lots of maybes and stuff - and the
figures seem high).

Our 407 is my wife's car and she has serious neck problems. And she
finds that the driver headrest is too far forward for comfort.
Has anyone else experienced this problem? Any suggestions?

The time has come for me to change the rear discs & pads on my 1999 406 HDI
I have changed various pads & discs on various makes and models of cars over
the  years,
The question I have, is there anything I need to look out for while doing

Noticed a flat with a puncture sitting on our drive. I managed to get
all 4 nuts out and put the guide nut in but when I pull the wheel just
won't come off. It is a rear wheel on a 307SW with alloys. I only have
the supplied jack so I don't want to pull too hard. I'm sure I have

I have decided to scrap my 306 diesel P reg but it has £40 of fuel in
it. I've been told it has an anti-syphon system.  I still need to
drive
it to the scrap yard.  Any ideas how I get it out?

Can anyone advise on likely causes for non start of the 2.0 HDi
The engine will not start when very cold - fine at all other times
I have replaced all glow plugs with new and it was working fine for several
weeks but then would not start. It has to be said, however, that it was not

peugeot 206, is the air filter cleaneable?
if yes, how?
thx

I recently purchased a 504 diesel 1979 sedan and will be picking up
this Sunday.
It seems to be in great condition, I'm curious if anyone else owns
this model?