hi can any one tell me please if Synthetic Dot 4 Brake fluid is ok for an L
reg 405? My handbook says to use Dot 4 Norm?? Many thanks to all who relpy.

Well i dont know what to do.had this 405 in for new belt, fan belt well
replaced the belt because it was making a noise.rattle and not gripping
pulleys.this was 4 weeks ago,now it has started again,so this time i am
going to replace the belt again and the lolly pop tensoir which i ...

I have a 406 estate on a 52 plate, fantastic car, but just one problem, when
I lock the car it often manages to unlock itself, when open the door the
alarm goes off, switch the ignition on and the alarm stops. When I lock it
with the button on the key fob I can hear all the doors ...

Just purchased a second hand right hand drive one (1.6HDi S) and need to get
in to slave some power off the power supply to the cigarette lighter and run
a cable from this so I can provide a permanent power supply for my mobile
phone and have my satnav permanently wired in the ...

What i would love too know why is it a heater hose always gets a hole
in it when all the car places are shut.and you have to wait till next
day to try and get one, i fitted a bit of garden hose 3/4 and had
problems fitting that, but it went on a little just so i can put clip

Just would to hear what poeple think of the new 308 and any problems.
thank you
---
avast! Antivirus: Outbound message clean.

Does anybody know the best place to get a replacement strut for the boot of
my 2004 307sw? I don't mind if it isn't an original product.
The boot will not stay up at all so I am guessing that they have both gone
and £40 each sounds rather on the expensive side.

I am in the process of changing the clutch in my 1993 405TD estate.
I have a Haynes manual, but too late I realised it was the petrol
version. (Halfrauds didn't have any 405 manuals in my local store).
Does anybody have the 405 diesel manual and if they have, could they

206 1.4 petrol 2002, 47000 ish miles.
While driving on the motorway the other day (after about an hour) the
engine management light came on (with a beep). Now, whenever I switch
the engine on, after a few seconds the same thing happens - light comes

I have a corroded air con pipe which is passing fluid badly. The pipe
appears to be aluminum, is about 10 mm diameter and the corrosion area is a
circular patch about 5 mm diameter. Is there any way of successfully
patching this pipe or is it a replacement job? I was hoping that ...

I'm trying to get some info on BE3 gearboxes. What I need to know is
would a Peugeot 306 BE3 geabox go onto a 205Gti late XU engine, or,
would any internal gears be interchangeable - in particular would the
5th gear fit the 205 box. I've been trying to find a longer 205 1.9 or

Having looked under the plastic covers that fit on top of the front
suspension struts i've found something a bit disturbing.
The top-nut on the left strut had turned loose quite a bit. The nut on the
righthand side is also quite loose.

I think some oil is comming into contact with the disrtibutor as I
have experinced some blue smoke from the bonnet, backfiring and poor
running.
Do you thing that leakeage from the top of the dipstick could cause

I am thinking of buying one of these:
http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=150232912484
I have a 2002 206 ('51 plate), but want to make sure it will work before
I buy.  Is the 206 at that time fully eobd compliant - ie will I be able

   I have an aging Peugeot 306 XSi ('95, 'N' reg). It had the head
gasket replaced several years ago. Recently I've been having
intermittent problems with overheating & loss of oil & coolant, which
I've managed to mitigate this by paying attention to keeping things